

- PT6523D - 板安装电源 > 直流转换器
- TLV320AIC32IRHBRG4 - 集成电路(IC) > 接口 > 编解码器
- SNJ55119FK - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- SN74HC573ADWR - 集成电路(IC) > 逻辑 > 锁存器
- TL1451AMFKB - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- SN74LVC2952APW - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TLV1822DR - 集成电路(IC) > 线性 > 比较器
- LM2853MHX-0.8/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TWL6032A2B4YFFR - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- SM32C6415EGLZ50AEP - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- TLV5638IDG4 - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- LM2931CT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM4936MHEVAL - 评估板 - 音频放大器
- TPS566247EVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- ADC161S626EB/NOPB - 开发板,套件,编程器 > 评估板 > 模数转换器(ADC)评估板
- DAC7613E - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- ISO3086TEVM - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- DAC811KUG4 - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- TPS79301QDBVRCT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS2010DR - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器



SN74ABT16601 - 具有三态输出的 18 位通用总线收发器
SN74ABT16601是TI德州仪器公司的一款通用总线收发器(UBT)产品,SN74ABT16601是具有三态输出的 18 位通用总线收发器,本站介绍了SN74ABT16601的封装应用图解、特点和优点、功能等,并给出了与SN74ABT16601相关的TI元器件型号供参考。
SN74ABT16601 - 具有三态输出的 18 位通用总线收发器 - 通用总线收发器(UBT) - 通用总线功能 - 德州仪器
These 18-bit universal bus transceivers combine D-type latches and D-type flip-flops to allow data flow in transparent, latched, clocked, and clock-enabled modes.
Data flow in each direction is controlled by output-enable ( and ), latch-enable (LEAB and LEBA), and clock (CLKAB and CLKBA) inputs. The clock can be controlled by the clock-enable ( and ) inputs. For A-to-B data flow, the device operates in the transparent mode when LEAB is high. When LEAB is low, the A data is latched if CLKAB is held at a high or low logic level. If LEAB is low, the A data is stored in the latch/flip-flop on the low-to-high transition of CLKAB. Output enable is active low. When is low, the outputs are active. When is high, the outputs are in the high-impedance state.
Data flow for B to A is similar to that of A to B, but uses , LEBA, CLKBA, and .
To ensure the high-impedance state during power up or power down, should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
The SN54ABT16601 is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74ABT16601 is characterized for operation from -40°C to 85°C.
- Members of the Texas Instruments WidebusTM Family
- State-of-the-Art EPIC-IIBTM BiCMOS Design Significantly Reduces Power Dissipation
- UBTTM (Universal Bus Transceiver) Combines D-Type Latches and D-Type Flip-Flops for Operation in Transparent, Latched, Clocked, or Clock-Enabled Mode
- Latch-Up Performance Exceeds 500 mA Per JEDEC Standard JESD-17
- Typical VOLP (Output Ground Bounce) < 0.8 V at VCC = 5 V, TA = 25°C
- Flow-Through Architecture Optimizes PCB Layout
- Package Options Include Plastic 300-mil Shrink Small-Outline (DL) and Thin Shrink Small-Outline (DGG) Packages and 380-mil Fine-Pitch Ceramic Flat (WD) Package Using 25-mil Center-to-Center Spacings
Widebus, EPIC-IIB, and UBT are trademarks of Texas Instruments Incorporated.
- LM98555 - CCD Driver
- SN74F573 - 具有三态输出的八路透明 D 类锁存器
- UA7812 - 12V 1.5A 固定正电压稳压器
- CDCLVC1110 - 低抖动 1:10 LVCMOS 扇出时钟缓冲器
- SN74BCT8245A - 具有八路总线收发器的 IEEE 标准 1149.1 (JTAG) 边界扫描测试设备
- SN65HVD251 - 工业 CAN 收发器
- ADS7851 - 双路,625 kSPS,16、14 和 12 位同步采样模数转换器
- CD4066B - CMOS 四路双向开关
- TPS737 - 单路输出 LDO、1A、可调节(1.2 至 5.0V)反向电流保护
- ADC104S051 - 4 通道 200 ksps 至 500 Ksps、10 位 A/D 转换器



