

- SN74LV245APWRG4 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TPS61500PWP - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器
- TPS259482AYWPR - 集成电路(IC) > 电源管理(PMIC) > 电流调节/管理
- 100130DCQR - 集成电路(IC) > 逻辑 > 锁存器
- LM5046MHX/NOPB - 集成电路(IC) > 电源管理(PMIC) > AC DC 转换器,离线开关
- LP2985IBP-3.0 - 电源管理IC - 稳压器 - 线性
- TL431IDBZRG4 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- TL16C550DPFB - 集成电路(IC) > 接口 > UART(通用异步接收器发送器)
- UCC28C54QDRQ1 - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- DRV8402DKDR - 集成电路(IC) > 电源管理(PMIC) > 电机驱动器,控制器
- TLV2762IP - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74V293-10PZA - 集成电路(IC) > 逻辑 > FIFO 存储器
- LM4140CCM-2.5 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- LMK6DA10000ADLFR - 晶体,振荡器,谐振器 > 振荡器
- LP8358MF-1.2/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74LV374ATPWRQ1 - 集成电路(IC) > 逻辑 > 触发器
- 74AC11240DBR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TLV5639CPWRG4 - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- TRS211IDWG4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TPD1E0B04DPLT - 电路保护 > 瞬态电压抑制器(TVS) > TVS 二极管



SN75154 - 四路差动线路接收器
SN75154是TI德州仪器公司的一款无产品,SN75154是四路差动线路接收器,本站介绍了SN75154的封装应用图解、特点和优点、功能等,并给出了与SN75154相关的TI元器件型号供参考。
SN75154 - 四路差动线路接收器 - 无 - RS-232收发器 - 德州仪器
The SN75154 is a monolithic low-power Schottky line receiver designed to satisfy the requirements of the standard interface between data terminal equipment and data communication equipment as defined by ANSI Standard EIA/TIA-232-E. Other applications are for relatively short, single-line, point-to-point data transmission and for level translators. Operation is normally from a single 5-V supply; however, a built-in option allows operation from a 12-V supply without the use of additional components. The output is compatible with most TTL circuits when either supply voltage is used.
In normal operation, the threshold-control terminals are connected to the VCC1 terminal, even if power is being supplied via the alternate VCC2 terminal. This provides a wide hysteresis loop, which is the difference between the positive-going and negative-going threshold voltages. See typical characteristics. In this mode of operation, if the input voltage goes to zero, the output voltage will remain at the low or high level as determined by the previous input.
For fail-safe operation, the threshold-control terminals are open. This reduces the hysteresis loop by causing the negative-going threshold voltage to be above zero. The positive-going threshold voltage remains above zero as it is unaffected by the disposition of the threshold terminals. In the fail-safe mode, if the input voltage goes to zero or an open-circuit condition, the output will go to the high level regardless of the previous input condition.
The SN75154 is characterized for operation from 0°C to 70°C.
- Meets or Exceeds the Requirements of ANSI Standard EIA/TIA-232-E and ITU Recommendation V.28
- Input Resistance . . . 3 k Over Full EIA/TIA-232-E Voltage Range
- Input Threshold Adjustable to Meet Fail-Safe Requirements Without Using External Components
- Built-In Hysteresis for Increased Noise Immunity
- Inverting Output Compatible With TTL
- Output With Active Pullup for Symmetrical Switching Speeds
- Standard Supply Voltages . . . 5 V or 12 V
- CD74HC670 - 高速 CMOS 逻辑 4 x 4 寄存器文件
- 66AK2L06 - 66AK2L06 多核 DSP+ARM KeyStone II 片上系统 (SoC)
- SN54AHCT08-SP - 四路 2 输入正与门
- MAX207 - 具有 +/-15kV ESD 保护的 5V 多通道 RS-232 线路驱动器/接收器
- SN54S51 - 与或反向门
- TLV1571 - 1 通道 10 位 1.25MSPS ADC,具有 8 通道输出、DSP/SPI、硬件可配置、低功耗
- LMK04816 - 具有双环 PLL 的三输入低噪声时钟抖动消除器
- LM78L15 - 3 端子负电压稳压器
- SN54LS157 - 四路 2 线路至 1 线路数据选择器/多路复用器
- WL1835MOD - TI WiLink8 单频带 Combo 模块 - Wi-Fi、BT、BLE 和 ANT



