

- SN74LS76AN3 - 集成电路(IC) > 逻辑 > 触发器
- SN65HVD30DG4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- PCF8574APWRE4 - 集成电路(IC) > 接口 > I/O 扩展器
- LMR10515YSDX/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- SN74LS157DE4 - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- SN74LV8153NG4 - 集成电路(IC) > 逻辑 > 移位寄存器
- TPS62220DDCRG4 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- LM34CAH/NOPB - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- TS5A3160DCKTG4 - 集成电路(IC) > 接口 > 模拟开关,多路复用器,解复用器
- UCC2803D - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- MAX3318CPWR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TMCS1101A3UQDR - 传感器,变送器 > 电流传感器
- MSP430FR2512IRHLR - 集成电路(IC) > 嵌入式 > 微控制器
- DM54S175W/883 - 集成电路(IC) > 逻辑 > 触发器
- ADS8339IDGSR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- SN74CBT3244CDW - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- SN74F157ADR - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- LM87CIMTX/NOPB - 集成电路(IC) > 电源管理(PMIC) > 热管理
- LMV841MG/NOPB - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TLV2462QPWRQ1 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器



SN75C185 - 低功耗多路驱动器和接收器
SN75C185是TI德州仪器公司的一款无产品,SN75C185是低功耗多路驱动器和接收器,本站介绍了SN75C185的封装应用图解、特点和优点、功能等,并给出了与SN75C185相关的TI元器件型号供参考。
SN75C185 - 低功耗多路驱动器和接收器 - 无 - RS-232收发器 - 德州仪器
The SN75C185 is a low-power BiMOS device containing three independent drivers and five receivers that are used to interface data terminal equipment (DTE) with data circuit-terminating equipment (DCE). Typically, the SN75C185 replaces one SN75188 and two SN75189 devices. This device conforms to TIA/EIA-232-F. The drivers and receivers of the SN75C185 are similar to those of the SN75C188 and SN75C189A, respectively. The drivers have a controlled output slew rate that is limited to a maximum of 30 V/us, and the receivers have filters that reject input noise pulses that are shorter than 1 us. Both these features eliminate the need for external components.
The SN75C185 uses the low-power BiMOS technology. In most applications, the receivers contained in this device interface to single inputs of peripheral devices such as ACEs, UARTS, or microprocessors. By using sampling, such peripheral devices usually are insensitive to the transition times of the input signals. If this is not the case, or for other uses, it is recommended that the SN75C185 receiver outputs be buffered by single Schmitt input gates or single gates of the HCMOS, ALS, or 74F logic families.
The SN75C185 is characterized for operation from 0°C to 70°C.
- Meets or Exceeds the Requirements of TIA/EIA-232-F and ITU Recommendation V.28
- Single Chip With Easy Interface Between UART and Serial-Port Connector
- Less Than 9-mW Power Consumption
- Wide Driver Supply Voltage...4.5 V to 13.2 V
- Driver Output Slew Rate Limited to 30 V/us Max
- Receiver Input Hysteresis...1100 mV Typ
- Push-Pull Receiver Outputs
- On-Chip Receiver 1-us Noise Filter
- Functionally Interchangeable With Texas Instruments SN75185
- Operates Up to 120 kbit/s Over a 3-Meter Cable (See Application Information for Conditions)
- MSP430BT5190 - 专为与基于 CC2560 TI Bluetooth 的解决方案配合使用而设计的 16 位微处理器
- TMP300-Q1 - 汽车类 1.8V 电阻可编程温度开关和模拟输出温度传感器
- TPL0102-100 - 具有 I2C 接口和非易失性存储器的 256 抽头双通道数字分压器
- SN74LV4051A-EP - 增强型产品 8 通道模拟多路复用器/多路解复用器
- ADC101S101 - 单通道、0.5 至 1 Msps、10 位 A/D 转换器
- TPS826765 - 采用 MicroSiP(tm) 封装的 600mA 完全集成式低噪声降压转换器
- LM3528 - 具有 128 指数明暗调节步进的高效、多显示 LED 驱动器
- UC1845A-SP - 电流模式 PWM 控制器
- UCC29900 - 完整周期控制器
- PTR08060W - 6A 输出 4.5V 至 14V 输入的非隔离宽输出可调节电源模块



