

- THS4601IDDAG3 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LM3370SD-3021/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TMS320C6727ZDHA250 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- SN74ABT646DW - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- INA186A4QDBVRQ1 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TS5N214PWG4 - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- TLC4501CDG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74HC04APWRG4 - 集成电路(IC) > 逻辑 > 门和反相器
- LM1871N - 射频和无线 > RF 其它 IC 和模块
- 5962-88738012A - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TLV7101828DSER - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- DAC8164EVM - 开发板,套件,编程器 > 评估板 > 数模转换器(DAC)评估板
- SN75115NS - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- SN75ALS164DW - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- CD4536BPWRG4 - 集成电路(IC) > 时钟/定时 > 可编程定时器和振荡器
- DAC081S101CIMKX/NOPB - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- LP3991TL-0.8/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LP3876ET-5.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- ADS8505IDBR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- DP83848YB-EVK/NOPB - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件



SN75C3221 - 3V 至 5.5V 多通道 RS-232 线路驱动器/接收器
SN75C3221是TI德州仪器公司的一款无产品,SN75C3221是3V 至 5.5V 多通道 RS-232 线路驱动器/接收器,本站介绍了SN75C3221的封装应用图解、特点和优点、功能等,并给出了与SN75C3221相关的TI元器件型号供参考。
SN75C3221 - 3V 至 5.5V 多通道 RS-232 线路驱动器/接收器 - 无 - RS-232收发器 - 德州仪器
The SN65C3221 and SN75C3221 consist of one line driver, one line receiver, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). These devices provide the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. These devices operate at data signaling rates up to 1 Mbit/s and a driver output slew rate of 24 V/µs to 150 V/µs.
Flexible control options for power management are available when the serial port is inactive. The auto-powerdown feature functions when FORCEON is low and FORCEOFF\ is high. During this mode of operation, if the devices do not sense a valid RS-232 signal on the receiver input, the driver output is disabled. If FORCEOFF\ is set low and EN\ is high, both the driver and receiver are shut off, and the supply current is reduced to 1 µA. Disconnecting the serial port or turning off the peripheral drivers causes the auto-powerdown condition to occur. Auto-powerdown can be disabled when FORCEON and FORCEOFF\ are high. With auto-powerdown enabled, the device is activated automatically when a valid signal is applied to the receiver input. The INVALID\ output notifies the user if an RS-232 signal is present at the receiver input. INVALID\ is high (valid data) if the receiver input voltage is greater than 2.7 V or less than 2.7 V, or has been between 0.3 V and 0.3 V for less than 30 µs. INVALID\ is low (invalid data) if the receiver input voltage is between 0.3 V and 0.3 V for more than 30 µs. Refer to Figure 5 for receiver input levels.
- Operate With 3-V to 5.5-V VCC Supply
- Operate up to 1 Mbit/s
- Low Standby Current ...1 µA Typical
- External Capacitors ...4 × 0.1 µF
- Accepts 5-V Logic Input With 3.3-V Supply
- RS-232 Bus-Pin ESD Protection Exceedsb ±15 kV Using Human-Body Model (HBM)
- Auto-Powerdown Feature Automatically Disables Drivers for Power Savings
- Applications
- Battery-Powered, Hand-Held, and Portable Equipment
- PDAs and Palmtop PCs
- Notebooks, Sub-Notebooks, and Laptops
- Digital Cameras
- Mobile Phones and Wireless Devices
- TPA3131D2 - 20W 无滤波器 D 类立体声放大器
- SN75ALS173 - 四路差动线路接收器
- BQ32000 - Serial RTC
- BQ24030 - 具有动态电源路径管理、输出稳压至 6V、电池稳压 4.2V 的充电器
- DRV601 - 2Vrm DirectPath? 无杂声可变输入增益线路驱动器
- TLK3132 - 双通道 600Mbps 至 3.75Gbps 多速率收发器
- CD74ACT573 - 具有三态输出的同向八路透明锁存器
- SN54LVC00A-SP - 四路 2 输入正与非门
- SN74LS33 - 具有集电极开路输出的双路 2 输入正或非缓冲器
- SN74GTLP817 - GTLP 到 LVTTL 1 至 6 驱动器



