• LVDS Display Series Interfaces Directly to LCD Display Panels With Integrated LVDS
• Package Options: 4.5-mm x 7-mm BGA, and 8.1-mm x 14-mm TSSOP
• 1.8-V Up to 3.3-V Tolerant Data Inputs to Connect Directly to Low-Power, Low-Voltage Application and Graphic Processors
• Transfer Rate up to 135 Mpps (Mega Pixel Per Second); Pixel Clock Frequency Range 10 MHz to 135 MHz
• Suited for Display Resolutions Ranging From HVGA up to HD With Low EMI
• Operates From a Single 3.3-V Supply and 170 mW (Typ.) at 75 MHz
• 28 Data Channels Plus Clock in Low-Voltage TTL to 4 Data Channels Plus Clock Out Low-Voltage Differential
• Consumes Less Than 1 mW When Disabled
• Selectable Rising or Falling Clock Edge Triggered Inputs
• ESD: 5-kV HBM
• Support Spread Spectrum Clocking (SSC)
• Compatible with all OMAP™ 2x, OMAP™ 3x, and DaVinci™ Application Processors

• LCD Display Panel Driver
• UMPC and Netbook PC
• Digital Picture Frame

The SN75LVDS83B FlatLink™ transmitter contains four 7-bit parallel-load serial-out shift registers, a 7X clock synthesizer, and five Low-Voltage Differential Signaling (LVDS) line drivers in a single integrated circuit. These functions allow 28 bits of single-ended LVTTL data to be synchronously transmitted over five balanced-pair conductors for receipt by a compatible receiver, such as the SN75LVDS82 and LCD panels with integrated LVDS receiver.

When transmitting, data bits D0 through D27 are each loaded into registers upon the edge of the input clock signal (CLKIN). The rising or falling edge of the clock can be selected via the clock select (CLKSEL) pin. The frequency of CLKIN is multiplied seven times, and then used to unload the data registers in 7-bit slices and serially. The four serial streams and a phase-locked clock (CLKOUT) are then output to LVDS output drivers. The frequency of CLKOUT is the same as the input clock, CLKIN.