• 16 LED Drivers (Each Output Programmable at Off, On, Programmable LED Brightness, or Programmable Group Dimming and Blinking Mixed With Individual LED Brightness)
• 16 Constant-Current Output Channels
• 256-Step (8-Bit) Linear Programmable Brightness Per LED Output Varying From Fully Off (Default) to Maximum Brightness Using a 97-kHz PWM Signal
• 256-Step Group Brightness Control Allows General Dimming [Using a 190-Hz PWM Signal From Fully Off to Maximum Brightness (Default)]
• 256-Step Group Blinking With Frequency Programmable From 24Hz to 10.73s and Duty Cycle From 0% to 99.6%
• Four Hardware Address Pins Allow 14 TLC59116 Devices to Be Connected to Same I2C Bus
• Four Software-Programmable I2C Bus Addresses (One LED Group Call Address and Three LED Sub Call Addresses) Allow Groups of Devices to Be Addressed at Same Time in Any Combination
• Software Reset Feature (SWRST Call) Allows Device to Be Reset Through I2C Bus
• Up to 14 Possible Hardware-Adjustable Individual I2C Bus Addresses Per Device, So That Each Device Can Be Programmed
• Open-Load and Overtemperature Detection Mode to Detect Individual LED Errors
• Output State Change Programmable on Acknowledge or Stop Command to Update Outputs Byte-by-Byte or All at Same Time (Default to Change on Stop)
• Output Current Adjusted Through an External Resistor
• Constant Output Current Range: 5mA to 120mA
• Maximum Output Voltage: 17V
• 25-MHz Internal Oscillator Requires No External Components
• 1-MHz Fast-mode Plus (FMT) Compatible I2C Bus Interface With 30-mA High-Drive Capability on SDA Output for Driving High-Capacitive Buses
• Internal Power-On Reset
• Noise Filter on SCL and SDA Inputs
• No Glitch on Power-Up
• Active-Low Reset
• Supports Hot Insertion
• Low Standby Current
• 3.3-V or 5-V Supply Voltage
• 5.5-V Tolerant Inputs
• Offered in 28-Pin Thin Shrink Small-Outline Package (TSSOP) (PW) and 32-Pin Quad Flatpack No Lead (QFN)
• –40 °C to 85 °C Operation

• Gaming
• Small Signage
• Industrial Equipment

The TLC59116 is an I2C bus controlled 16-channel LED driver that is optimized for red/green/blue/amber (RGBA) color mixing and backlight application. Each LED output has its own 8-bit resolution (256steps) fixed-frequency individual PWM controller that operates at 97kHz, with a duty cycle that is adjustable from 0% to 99.6%.

• BQ77PL157A4225 - 用于 3 至 6 节锂离子/聚合物电池的电压保护
• TPS54383 - 具有内部补偿的 4.5V 至 28V 输入、双路 3A 输出、300kHz 降压转换器
• LM5035B - 具有集成半桥接和同步 FET 驱动器的 PWM 控制器
• SN54LS673 - 16 位移位寄存器
• DRV8823-Q1 - 汽车类 1.5A 四刷或双极步进电机驱动器（串行控制）
• UCC24650 - Output Voltage Monitor with Wake-Up Alarm Signaling
• DS100MB201 - Dual Lane 2:1/1:2 Mux/Buffer with Equalization
• SN74LS75 - 四路双稳态锁存器
• SN74AUC2G00 - 双路 2 输入正与非门
• TPS7A3501 - Low Noise, High PSRR 1A Active Filter