The devices are USB dedicated charging port (DCP) controllers. An auto-detect feature monitors USB data line voltage, and automatically provides the correct electrical signatures on the data lines to charge compliant devices among the following dedicated charging schemes:

Divider 1 DCP, required to apply 2 V and 2.7 V on the D+ and D– Lines respectively (TPS2513, TPS2514) Divider 2 DCP, required to apply 2.7 V and 2 V on the D+ and D– Lines respectively (TPS2513, TPS2514) Divider 3 DCP, required to apply 2.7 V and 2.7 V on the D+ and D- Lines respectively (TPS2513A, TPS2514A) BC1.2 DCP, required to short the D+ Line to the D– Line Chinese Telecom Standard YD/T 1591-2009 Shorted Mode, required to short the D+ Line to the D– Line 1.2 V on both D+ and D– Lines

• Supports USB DCP Shorting D+ Line to D– Line per USB Battery Charging Specification, Revision 1.2 (BC1.2)
• Supports Shorted Mode (Shorting D+ Line to D– Line) per Chinese Telecommunication Industry Standard YD/T 1591-2009
• Supports USB DCP Applying 2.7 V on D+ Line and 2 V on D– line (or USB DCP Applying 2 V on D+ Line and 2.7 V on D– Line) (TPS2513, TPS2514)
• Supports USB DCP Applying 2.7 V on D+ Line and 2.7 V on D‐ Line (TPS2513A, TPS2514A)
• Supports USB DCP Applying 1.2 V on D+ and D– Lines
• Automatically Switch D+ and D– Lines Connections for an Attached Device
• Dual USB Port Controller (TPS2513, TPS2513A)
• Single USB Port Controller (TPS2514, TPS2514A)
• Operating Range: 4.5 V to 5.5 V
• Available in SOT23-6 Package

• TLV5624 - 8 位 1.0 至 3.5us DAC，具有串行输入、可编程内部参考和稳定时间
• SN74ABT8996 - 10 位可寻址扫描端口，多点可寻址 IEEE 标准 1194.1 (JTAG) TAP 收发器
• TL2845B - TL284xB, TL384xB
• CD4027B-MIL - CMOS 双路 J-K 主/从触发器
• SN74HC684 - 8 位幅度比较器
• MSP430G2302-EP - .混合信号微控制器
• PTH08T250W - 50-A, 4.5-V to 14-V INPUT, NON-ISOLATED, WIDE-OUTPUT,
• TLV702-Q1 - 汽车类 300mA、低 IQ、低压降稳压器
• TPS626765 - 650mA，6 MHz 高效率，0.4mm 规格芯片级封装，降压转换器，Vout=1.05V
• PCM5102A-Q1 - 具有 32 位、384kHz PCM 接口的 2VRMS DirectPath?、112/106/100dB 音频立体声 DAC