TPS60205 - 具有电源状态良好指示的稳压 3.3V 低纹波充电泵

TPS60205是TI德州仪器公司的一款电荷泵（无感应器）产品，TPS60205是具有电源状态良好指示的稳压 3.3V 低纹波充电泵，本站介绍了TPS60205的封装应用图解、特点和优点、功能等，并给出了与TPS60205相关的TI元器件型号供参考。

TPS60205 - 具有电源状态良好指示的稳压 3.3V 低纹波充电泵 - 电荷泵（无感应器） - DC/DC开关稳压器 - 德州仪器

产品描述

The TPS6020x step-up, regulated charge pumps generate a 3.3-V ±4% output voltage from a 1.8-V to 3.6-V input voltage. The devices are typically powered by two Alkaline, NiCd, or NiMH battery cells and operate down to a minimum supply voltage of 1.6 V. Continuous output current is a minimum of 100 mA from a 2-V input. Only four external capacitors are needed to build a complete low-ripple dc/dc converter. The push-pull operating mode of two single-ended charge pumps assures the low output voltage ripple, as current is continuously transferred to the output.

The devices operate in the newly developed LinSkip mode. In this operating mode, the device switches seamlessly from the power saving pulse-skip mode at light loads to the low-noise constant-frequency, linear-regulation mode once the output current exceeds the LinSkip threshold of about 7 mA. Even in pulse-skip mode, the output ripple is maintained at a very low level because the output resistance of the charge pump is still regulated.

Three operating modes can be programmed using the EN pin. EN = low disables the device, shuts down all internal circuits, and disconnects the output from the input. EN = high enables the device and programs it to run from the internal oscillator. The devices operate synchronized to an external clock signal if EN is clocked; thus, switching harmonics can be controlled and minimized. The devices include a low-battery detector that issues a warning if the battery voltage drops below a user-defined threshold voltage, or a power-good detector that goes active when the output voltage reaches about 90% of its nominal value.

Device options with either a low-battery or power good detector are available. This dc/dc converter requires no inductors, therefore, EMI of the system is reduced to a minimum. It is available in the small 10-pin MSOP package (DGS).

产品特性

Regulated 3.3-V Output Voltage With up to 100-mA Output Current From a 1.8-V to 3.6-V Input Voltage
Less Than 5-mV(PP) Output Voltage Ripple Achieved With Push-Pull Topology
Integrated Low-Battery and Power-Good Detector
Switching Frequency Can Be Synchronized to External Clock Signal
Extends Battery Usage With up to 90% Efficiency and 35-uA Quiescent Supply Current
Easy-to-Design, Low Cost, Low EMI Power Supply Since No Inductors Are Used
0.05-uA Shutdown Current, Battery is Isolated From Load in Shutdown Mode
Compact Converter Solution in UltraSmall 10-pin MSOP With Only Four External Capacitors Required
Evaluation Module Available (TPS60200EVM-145)
applications
- Replaces DC/DC Converters With Inductors in Battery Powered Applications Like:
  - Two Battery Cells to 3.3-V Conversion
  - MP3 Portable Audio Players
  - Battery-Powered Microprocessor Systems
  - Backup-Battery Boost Converters
  - PDA's, Organizers, and Cordless Phones
  - Handheld Instrumentation
  - Glucose Meters and Other Medical Instruments

下面可能是您感兴趣的TI德州仪器公司电荷泵（无感应器）元器件

TI公司产品现货专家，订购TI公司产品不限最低起订量，TI芯片大陆现货即时发货，香港库存3-5天发货，海外库存7-10天发货

寻找全球TI代理商现货货源 - TI公司（德州仪器）电子元件在线订购