



- TLV2772MDRG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LM2586T-3.3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TPS7A3001DGNR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74LVC2G02DCURG4 - 集成电路(IC) > 逻辑 > 门和反相器
- TPS72728YFFR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- PTH03050WAZT - 板安装电源 > 直流转换器
- ADS42JB46IRGCR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- DS90CP22MT - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- DRV425RTJR - 传感器,变送器 > 磁性传感器 > 线性、罗盘(IC)
- LM26CIM5-XPA/NOPB - 传感器,变送器 > 温度传感器 > 温控器 - 固态
- TPS79133DBVR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN65LVDM050DR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- CD74ACT02E - 集成电路(IC) > 逻辑 > 门和反相器
- LF444CN/NOPB - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- HCPL2631 - 隔离器 > 光隔离器 > 逻辑输出光隔离器
- TPS560200QDGKTQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- LP3984IMFX-1.8/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TUSB1064RGFTQ1 - 集成电路(IC) > 接口 > 信号缓冲器、中继器、分离器
- UC5603J - 集成电路(IC) > 接口 > 信号端接器
- MSP430G2413IRHB32T - 集成电路(IC) > 嵌入式 > 微控制器



TPS61000 - 具有可调节输出的低输入电压升压转换器
TPS61000是TI德州仪器公司的一款转换器(集成开关)产品,TPS61000是具有可调节输出的低输入电压升压转换器,本站介绍了TPS61000的封装应用图解、特点和优点、功能等,并给出了与TPS61000相关的TI元器件型号供参考。
TPS61000 - 具有可调节输出的低输入电压升压转换器 - 转换器(集成开关) - DC/DC开关稳压器 - 德州仪器
- Start-Up Into a Full Load With Supply Voltages as Low as 0.9 V Over Full Temperature Range
- Minimum 100-mA Output Current From 0.8-V Supply Voltage, 250 mA From 1.8 V
- High Power Conversion Efficiency, up to 90%
- Power-Save Mode for Improved Efficiency at Low Output Currents
- Device Quiescent Current Less Than 50 µA
- Added System Security With Integrated Low-Battery Comparator
- Low-EMI Converter (Integrated Antiringing Switch Across Inductor)
- Micro-Size 10-Pin MSOP Package
- Evaluation Modules Available (TPS6100xEVM–156)
- Single- and Dual-Cell Battery Operated Products
- MP3-Players and Wireless Headsets
- Pagers and Cordless Phones
- Portable Medical Diagnostic Equipment
- Remote Controls
The TPS6100x devices are boost converters intended for systems that are typically operated from a single- or dual-cell nickel-cadmium (NiCd), nickel-metal hydride (NiMH), or alkaline battery. The converter output voltage can be adjusted from 1.5 V to a maximum of 3.3 V and provides a minimum output current of 100 mA from a single battery cell and 250 mA from two battery cells. The converter starts up into a full load with a supply voltage of 0.9 V and stays in operation with supply voltages as low as 0.8 V.
The converter is based on a fixed-frequency, current-mode pulse-width-modulation (PWM) controller that goes into power-save mode at low load currents. The current through the switch is limited to a maximum of 1100 mA, depending on the output voltage. The current sense is integrated to further minimize external component count. The converter can be disabled to minimize battery drain when the system is put into standby.
A low-EMI mode is implemented to reduce interference and radiated electromagnetic energy that is caused by the ringing of the inductor when the inductor discharge-current decreases to zero. The device is packaged in the space-saving 10-pin MSOP package.
| PART NUMBER | PACKAGE | BODY SIZE (NOM) |
|---|---|---|
| TPS6100x | VSSOP (10) | 3.00 mm × 3.00 mm |
- SN74ALVCH162836 - 具有三态输出的 20 位通用总线驱动器
- ADS1278 - 八路、144kHz、24 位同步采样 Σ-Δ ADC
- DAC5311-Q1 - 1.8 V to 5.5 V, 80-mA 8-Bit Low-Power
- LM25576 - SIMPLE SWITCHER? 42V,3A 降压开关稳压器
- ISO7231C-Q1 - 汽车类三通道 2/1 25Mbps 数字隔离器
- UCC1804 - 低功耗 BiCMOS 电流模式 PWM
- TPS2811-Q1 - 具有内部稳压器的汽车类反向双路高速 MOSFET 驱动器
- TPS76828-Q1 - 汽车类单输出 LDO、1.0A、固定电压 (2.8V)、低静态电流
- DS92CK16 - 3V BLVDS 1 至 6 时钟缓冲器/总线收发器
- UCC27424-EP - 增强型产品双路 4A Mosfet 驱动器



