



- UC1825VTD2 - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- LM2936BMX-3.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- UC3865NG4 - 集成电路(IC) > 电源管理(PMIC) > AC DC 转换器,离线开关
- COP8SAA728M8 - 集成电路(IC) > 嵌入式 > 微控制器
- ADC1005BCJ-1 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- ADS7810UB - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- PT4314C - 板安装电源 > 直流转换器
- SN74HC164DRG4 - 集成电路(IC) > 逻辑 > 移位寄存器
- ADC141S626CIMMX/NOPB - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- TLV2544ID - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- OPA2391DGKR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- ADC08138CIWMX - 数据采集 - 模数转换器(ADC)
- AM3505AZER - 集成电路(IC) > 嵌入式 > 微处理器
- SN74CB3T3384DWR - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- AFE8128IAPK - 射频和无线 > 射频收发器 IC
- THVD1410DGK - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- THS4120CDGKG4 - 线性器件 - 放大器 - 仪器、运算放大器、缓冲放大器
- LM4550VHX - 集成电路(IC) > 接口 > 编解码器
- SMJ68CE16S-55JDM - 集成电路(IC) > 存储器 > 存储器
- LP2989IMX-5.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性



TPS61005 - 具有固定 3.0V 输出的低输入电压升压转换器
TPS61005是TI德州仪器公司的一款转换器(集成开关)产品,TPS61005是具有固定 3.0V 输出的低输入电压升压转换器,本站介绍了TPS61005的封装应用图解、特点和优点、功能等,并给出了与TPS61005相关的TI元器件型号供参考。
TPS61005 - 具有固定 3.0V 输出的低输入电压升压转换器 - 转换器(集成开关) - DC/DC开关稳压器 - 德州仪器
- Start-Up Into a Full Load With Supply Voltages as Low as 0.9 V Over Full Temperature Range
- Minimum 100-mA Output Current From 0.8-V Supply Voltage, 250 mA From 1.8 V
- High Power Conversion Efficiency, up to 90%
- Power-Save Mode for Improved Efficiency at Low Output Currents
- Device Quiescent Current Less Than 50 µA
- Added System Security With Integrated Low-Battery Comparator
- Low-EMI Converter (Integrated Antiringing Switch Across Inductor)
- Micro-Size 10-Pin MSOP Package
- Evaluation Modules Available (TPS6100xEVM–156)
- Single- and Dual-Cell Battery Operated Products
- MP3-Players and Wireless Headsets
- Pagers and Cordless Phones
- Portable Medical Diagnostic Equipment
- Remote Controls
The TPS6100x devices are boost converters intended for systems that are typically operated from a single- or dual-cell nickel-cadmium (NiCd), nickel-metal hydride (NiMH), or alkaline battery. The converter output voltage can be adjusted from 1.5 V to a maximum of 3.3 V and provides a minimum output current of 100 mA from a single battery cell and 250 mA from two battery cells. The converter starts up into a full load with a supply voltage of 0.9 V and stays in operation with supply voltages as low as 0.8 V.
The converter is based on a fixed-frequency, current-mode pulse-width-modulation (PWM) controller that goes into power-save mode at low load currents. The current through the switch is limited to a maximum of 1100 mA, depending on the output voltage. The current sense is integrated to further minimize external component count. The converter can be disabled to minimize battery drain when the system is put into standby.
A low-EMI mode is implemented to reduce interference and radiated electromagnetic energy that is caused by the ringing of the inductor when the inductor discharge-current decreases to zero. The device is packaged in the space-saving 10-pin MSOP package.
| PART NUMBER | PACKAGE | BODY SIZE (NOM) |
|---|---|---|
| TPS6100x | VSSOP (10) | 3.00 mm × 3.00 mm |
- SN74LV273A - 具有清零功能的八路 D 类触发器
- MSP430G2212 - MSP430G2x52、MSP430G2x12 混合信号微处理器
- SN74LS298 - 具有存储器的四路 2 输入 多路复用器
- PCM1681-Q1 - 105dB SNR 8 通道音频 DAC(汽车类)
- TPS77428 - 快速瞬态响应 250mA LDO 稳压器,具有电源状态良好指示、MSOP-8 封装
- TPS65631W - +4.6V/-1.4 至 -4.4V 双输出 200mA AMOLED 显示屏电源
- LP3918 - 电池充电管理和稳压器单元
- TLV863M - 监控器和复位IC
- MSP430FR5725 - MSP430FR573x MSP430FR572x 混合信号微控制器
- CSD95373BQ5M - 同步降压 NexFET 功率级,CSD95373BQ5M



