



- LP2985AIM5-2.7/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- BQ2945SN-C409 - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- 74AHCT1G04DCKRE4 - 集成电路(IC) > 逻辑 > 门和反相器
- DLPC23STZDQRQ1 - 集成电路(IC) > 专用 IC
- LP5900TL-2.8EV - 开发板,套件,编程器 > 评估板 > 线性稳压器评估板
- CD4072BE - 集成电路(IC) > 逻辑 > 门和反相器
- SN74AUC2G00DCURG4 - 集成电路(IC) > 逻辑 > 门和反相器
- MC1408P8 - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- ADC1175-50CIMT/NOPB - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- ADS8332EVM - 开发板,套件,编程器 > 评估板 > 模数转换器(ADC)评估板
- SN65LVDM176D - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- MSP-EVK430S320 - 开发板,套件,编程器 > 评估板 > 嵌入式 MCU、DSP 评估板
- DRV8434PRGER - 集成电路(IC) > 电源管理(PMIC) > 电机驱动器,控制器
- UCC28501DWTRG4 - 电源管理IC - PFC(功率因数校正)
- THS3202DGK - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- BQ29419PWR - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- LMC6024IMX/NOPB - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- 5962-9321604QHA - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS40009EVM-001 - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- PT6681D - 直流转换器



TPS61006 - 具有固定 3.3V 输出的低输入电压升压转换器
TPS61006是TI德州仪器公司的一款转换器(集成开关)产品,TPS61006是具有固定 3.3V 输出的低输入电压升压转换器,本站介绍了TPS61006的封装应用图解、特点和优点、功能等,并给出了与TPS61006相关的TI元器件型号供参考。
TPS61006 - 具有固定 3.3V 输出的低输入电压升压转换器 - 转换器(集成开关) - DC/DC开关稳压器 - 德州仪器
- Start-Up Into a Full Load With Supply Voltages as Low as 0.9 V Over Full Temperature Range
- Minimum 100-mA Output Current From 0.8-V Supply Voltage, 250 mA From 1.8 V
- High Power Conversion Efficiency, up to 90%
- Power-Save Mode for Improved Efficiency at Low Output Currents
- Device Quiescent Current Less Than 50 µA
- Added System Security With Integrated Low-Battery Comparator
- Low-EMI Converter (Integrated Antiringing Switch Across Inductor)
- Micro-Size 10-Pin MSOP Package
- Evaluation Modules Available (TPS6100xEVM–156)
- Single- and Dual-Cell Battery Operated Products
- MP3-Players and Wireless Headsets
- Pagers and Cordless Phones
- Portable Medical Diagnostic Equipment
- Remote Controls
The TPS6100x devices are boost converters intended for systems that are typically operated from a single- or dual-cell nickel-cadmium (NiCd), nickel-metal hydride (NiMH), or alkaline battery. The converter output voltage can be adjusted from 1.5 V to a maximum of 3.3 V and provides a minimum output current of 100 mA from a single battery cell and 250 mA from two battery cells. The converter starts up into a full load with a supply voltage of 0.9 V and stays in operation with supply voltages as low as 0.8 V.
The converter is based on a fixed-frequency, current-mode pulse-width-modulation (PWM) controller that goes into power-save mode at low load currents. The current through the switch is limited to a maximum of 1100 mA, depending on the output voltage. The current sense is integrated to further minimize external component count. The converter can be disabled to minimize battery drain when the system is put into standby.
A low-EMI mode is implemented to reduce interference and radiated electromagnetic energy that is caused by the ringing of the inductor when the inductor discharge-current decreases to zero. The device is packaged in the space-saving 10-pin MSOP package.
| PART NUMBER | PACKAGE | BODY SIZE (NOM) |
|---|---|---|
| TPS6100x | VSSOP (10) | 3.00 mm × 3.00 mm |
- SN751177 - 双路差动驱动器/接收器对
- SN74128 - 50Ω 线路驱动器
- SN7425 - 双路 4 输入正或非门
- SN65HVD3082E - 低功耗半双工 RS-485 收发器
- SN74AS808B - 六路 2 输入与驱动器
- PCM5101A-Q1 - 具有 32 位、384kHz PCM 接口的 2VRMS DirectPath?、112/106/100dB 音频立体声 DAC
- TMS320F28052F - 具有 InstaSPIN-FOC 的 Piccolo 微控制器
- SN74AHCT16374 - 具有三态输出的 16 位边沿 D 类触发器
- LM22677 - 具有同步或可调开关频率的 5A SIMPLE SWITCHER? 降压稳压器
- CD74HC7046A - 带 VCO 和锁定检测器的高速 CMOS 逻辑锁相环



