TPS77918 - 采用 MSOP8 封装的 250mA 低压降 (LDO) 稳压器和 SVS，启用高电平

TPS77918是TI德州仪器公司的一款单通道LDO产品，TPS77918是采用 MSOP8 封装的 250mA 低压降 (LDO) 稳压器和 SVS，启用高电平，本站介绍了TPS77918的封装应用图解、特点和优点、功能等，并给出了与TPS77918相关的TI元器件型号供参考。

TPS77918 - 采用 MSOP8 封装的 250mA 低压降 (LDO) 稳压器和 SVS，启用高电平 - 单通道LDO - 线性稳压器(LDO) - 德州仪器

产品描述

The TPS779xx is a low-dropout regulator with integrated power-on reset. The device is capable of supplying 250 mA of output current with a dropout of 200 mV (TPS77930). Quiescent current is 92 uA at full load dropping down to 1 uA when the device is disabled. The device is optimized to be stable with a wide range of output capacitors including low ESR ceramic (10uF) or low capacitance (1uF) tantalum capacitors. The device has extremely low noise output performance (55 uVrms) without using any added filter capacitors. TPS779xx is designed to have a fast transient response for larger load current changes.

The TPS779xx is offered in 1.8-V, 2.5-V, and 3-V fixed-voltage versions and in an adjustable version (programmable over the range of 1.5 V to 5.5 V). Output voltage tolerance is 2% over line, load, and temperature ranges. The TPS779xx family is available in 8-pin MSOP (DGK) packages.

Because the PMOS device behaves as a low-value resistor, the dropout voltage is very low (typically 200 mV at an output current of 250 mA for 3.3 volt option) and is directly proportional to the output current. Additionally, since the PMOS pass element is a voltage-driven device, the quiescent current is very low and independent of output loading (typically 92 uA over the full range of output current, 0 mA to 250 mA). These two key specifications yield a significant improvement in operating life for battery-powered systems.

The device is enabled when the EN pin is connected to a high-level input voltage. This LDO family also features a sleep mode; applying a TTL low signal to EN (enable) shuts down the regulator, reducing the quiescent current to less than 1 uA at TJ = 25°C.

The TPS779xx features an integrated power-on reset, commonly used as a supply voltage supervisor (SVS), or reset output voltage. The RESET\ output of the TPS779xx initiates a reset in DSP, microcomputer, or microprocessor systems at power-up and in the event of an undervoltage condition. An internal comparator in the TPS779xx monitors the output voltage of the regulator to detect an undervoltage condition on the regulated output voltage. When OUT reaches 95% of its regulated voltage, RESET\ will go to a high-impedance state after a 220 ms delay. RESET\ will go to low-impedance state when OUT is pulled below 95% (i.e. over load condition) of its regulated voltage.

产品特性

Open Drain Power-On Reset With 220-ms Delay
250-mA Low-Dropout Voltage Regulator
Available in 1.8-V, 2.5-V, 3-V, Fixed Output and Adjustable Versions
Dropout Voltage Typically 200 mV at 250 mA (TPS77930)
Ultralow 92-uA Quiescent Current (Typ)
8-Pin MSOP (DGK) Package
Low Noise (55 uVrms) With No Bypass Capacitor (TPS77918)
2% Tolerance Over Specified Conditions For Fixed-Output Versions
Fast Transient Response
Thermal Shutdown Protection
See the TPS773xx and TPS774xx Family of Devices for Active Low Enable

下面可能是您感兴趣的TI德州仪器公司单通道LDO元器件

TI公司产品现货专家，订购TI公司产品不限最低起订量，TI芯片大陆现货即时发货，香港库存3-5天发货，海外库存7-10天发货

寻找全球TI代理商现货货源 - TI公司（德州仪器）电子元件在线订购