

- LM358ADR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- DRV2700EVM-HV500 - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- SN74SSTUB32866NMJR - 集成电路(IC) > 逻辑 > 专用逻辑器件
- SN74AUC32244GKER - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- LM2653MTCX-ADJ/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- BQ24305DSGR - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- SN74HC32PW - 集成电路(IC) > 逻辑 > 门和反相器
- TPS6285021HQDRLRQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TAS3108IADCPR - 集成电路(IC) > 音频专用
- SNBB027A2RSLR - 未分类 > 未分类
- TLV70237DBVR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74CBTLV16800VR - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- 54F573DM-MLS - 集成电路(IC) > 逻辑 > 锁存器
- LM3557SD-2/NOPB - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器
- OPA131U - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SNJ54AS241AJ - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TL072CPSR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LMS1587CSX-1.5/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74ALS323DW - 集成电路(IC) > 逻辑 > 移位寄存器
- LMH6504MMX - 线性器件 - 放大器 - 仪器、运算放大器、缓冲放大器



TXB0304 - 具有完全对称的 0.9V 至 3.6V 范围的 4 位双向自动方向感应转换器
TXB0304是TI德州仪器公司的一款双向电压转换产品,TXB0304是具有完全对称的 0.9V 至 3.6V 范围的 4 位双向自动方向感应转换器,本站介绍了TXB0304的封装应用图解、特点和优点、功能等,并给出了与TXB0304相关的TI元器件型号供参考。
TXB0304 - 具有完全对称的 0.9V 至 3.6V 范围的 4 位双向自动方向感应转换器 - 双向电压转换 - 电压电平转换 - 德州仪器
- Fully Symmetric Supply Voltages, 0.9 V to 3.6 V on A Port and 0.9 V to 3.6 V
- VCC Isolation Feature – If Either VCC Input is at GND, all Outputs are in High-Impedance State
- OE Input Circuit Referenced to VCCA
- Low Power Consumption, 5 μA Max (ICCA or ICCB)
- Ioff Supports Partial-Power-Down Mode Operation
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22
- 8000 V Human-Body Model (A114-B)
- 1000 V Charged-Device Model (C101)
- Personal Electronics
- Industrial
- Enterprise
- Telecom
This 4-bit non-inverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 0.9 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 0.9 V to 3.6 V. This allows for low Voltage bidirectional translation between 1 V, 1.2 V, 1.5 V, 1.8 V, 2.5 V and 3.3 V voltage nodes. For the TXB0304, when the output-enable (OE) input is low, all outputs are placed in the high-impedance state. To ensure the high-impedance state during power up or power down, OE should be tied to GND through a pull-down resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver. The OE device control pin input circuit is supplied by VCCA. This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. The only difference between TXB0304 and TXBN0304 is the OE signal being active low and active high respectively.
| PART NUMBER | PACKAGE | BODY SIZE (NOM) |
|---|---|---|
| TXB0304 | RUT UQFN (12) | 2.00 mm × 1.70 mm |
| RSV UQFN (16) | 2.60 mm × 1.80 mm |
- SN74LV1T00 - 具有 CMOS 逻辑电平转换器的单电源 2 输入正与非门
- VSP5610 - 16 位 35MSPS 4 通道成像模拟前端
- DAC7563T - DACxx6xT 16 位双路低功耗超低毛刺脉冲缓冲电压输出 DAC
- TPS2816 - 具有源上拉和内部稳压器的反向高速 MOSFET 驱动器
- SN74V293-EP - 增强型产品 65536 X 18 同步 Fifo 存储器
- TPS53015 - 用于具有电源良好指示的低压电源轨的单路同步降压控制器
- TPS54372-Q1 - 汽车类 3A 输出跟踪/终端同步 PWM 转换开关
- TPS2330 - 具有电源状态良好指示、工作态低电平使能输入的 3-13V 单路热交换 IC
- TPS7B4250-Q1 - 汽车类低压降电压跟踪低压降稳压器 (LDO)
- UCC28084 - 具有可编程斜率补偿的电流模式推挽 PWM



