

- LM25066IAPSQ/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- LM833DGKT - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LP2989IMX-1.8/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- UCD74120RVFR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- OPA4340UA - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LM2734ZMKX - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- OPA2990SIRUGR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS54162EVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- LM3444MR16BSTRB/NOPB - 开发板,套件,编程器 > 评估板 > LED 驱动器评估板
- CLC5602IMX - 集成电路(IC) > 线性 > 放大器 > 视频放大器和模块
- THS5661AIDW - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- TLV70732DQNR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- 9528DC - 集成电路(IC) > 逻辑 > 触发器
- TL598CDR - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- AFE4490RHAT - 集成电路(IC) > 数据采集 > 模拟前端(AFE)
- LM3880QMFX-1AF/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电源控制器,监视器
- TPS51116RGE - 集成电路(IC) > 电源管理(PMIC) > 特殊用途稳压器
- SN74V293-10PZA - 集成电路(IC) > 逻辑 > FIFO 存储器
- SN74AHCT574N - 集成电路(IC) > 逻辑 > 触发器
- LM3670MFX-ADJ/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器



UC2906 - 铅酸线性充电管理 IC
UC2906是TI德州仪器公司的一款电池充电器IC产品,UC2906是铅酸线性充电管理 IC,本站介绍了UC2906的封装应用图解、特点和优点、功能等,并给出了与UC2906相关的TI元器件型号供参考。
UC2906 - 铅酸线性充电管理 IC - 电池充电器IC - 电池管理产品 - 德州仪器
The UC2906 series of battery charger controllers contains all of the necessary circuitry to optimally control the charge and hold cycle for sealed lead-acid batteries. These integrated circuits monitor and control both the output voltage and current of the charger through three separate charge states; a high current bulk-charge state, a controlled over-charge, and a precision float-charge, or standby, state.
Optimum charging conditions are maintained over an extended temperature range with an internal reference that tracks the nominal temperature characteristics of the lead-acid cell. A typical standby supply current requirement of only 1.6mA allows these ICs to predictably monitor ambient temperatures.
Separate voltage loop and current limit amplifiers regulate the output voltage and current levels in the charger by controlling the onboard driver. The driver will supply up to 25mA of base drive to an external pass device. Voltage and current sense comparators are used to sense the battery condition and respond with logic inputs to the charge state logic. A charge enable comparator with a trickle bias output can be used to implement a low current turn-on mode of the charger, preventing high current charging during abnormal conditions such as a shorted battery cell.
Other features include a supply under-voltage sense circuit with a logic output to indicate when input power is present. In addition the over-charge state of the charger can be externally monitored and terminated using the over-charge indicate output and over-charge terminate input.
- Optimum Control for Maximum Battery Capacity and Life
- Internal State Logic Provides Three Charge States
- Precision Reference Tracks Battery Requirements Over Temperature
- Controls Both Voltage and Current at Charger Output
- System Interface Functions
- Typical Standby Supply Current of only 1.6mA
- LM8333 - 移动 I/O 配套支持 Key-Scan、I/O 扩展、PWM 和 ACCESS.bus 主机接口
- BQ24006 - 锂离子线性 (8.2V 8.4V) 充电管理 IC,用于具有集成 FET、双色 LED 的两节应用领域
- LM2734Z - 超薄 SOT23 1A 负载降压 DC-DC 稳压器
- TPS54541 - 具有软启动和 Eco-mode 的 TPS54541 4.5V 至 60 V 输入、5A、降压 DC-DC 转换器
- SN74F21 - 二路 4 输入正与门
- TLV320DAC23 - 具有耳机放大器的低功耗立体声音频 DAC
- SN54LVTH162373 - 具有三态输出的 3.3V ABT 16 位透明 D 类锁存器
- TCA1116 - 低电压 16 位 I2C 和 SMBus 低功耗 I/O 扩展器,TCA1116
- TPS61012 - 具有固定 1.8V 输出的低输入电压同步升压转换器
- MSP430FG438 - 16 位超低功耗 MCU,具有 48KB 闪存、2KB RAM、12 位 ADC、双 DAC、DMA、3 个 OPAMP 和 128 段 LCD



