UCC384-ADJ - 单输出 LDO、500mA、可调节电压（15 至 1.25V）、低静态电流、宽输入电压范围

UCC384-ADJ是TI德州仪器公司的一款单通道LDO产品，UCC384-ADJ是单输出 LDO、500mA、可调节电压（15 至 1.25V）、低静态电流、宽输入电压范围，本站介绍了UCC384-ADJ的封装应用图解、特点和优点、功能等，并给出了与UCC384-ADJ相关的TI元器件型号供参考。

UCC384-ADJ - 单输出 LDO、500mA、可调节电压（15 至 1.25V）、低静态电流、宽输入电压范围 - 单通道LDO - 线性稳压器(LDO) - 德州仪器

产品描述

The UCC384-x family of negative linear-series pass regulators is tailored for low-dropout applications where low-quiescent power is important. Fabricated with a BCDMOS technology ideally suited for low input-to-output differential applications, the UCC384-x passes 0.5 A while requiring only 0.2 V of input-voltage headroom. Dropout voltage decreases linearly with output current, so that dropout at 50 mA is less than 20 mV.

Quiescent current consumption for the device under normal (non-dropout) conditions is typically 200 uA. An integrated charge pump is internally enabled only when the device is operating near dropout with low VIN. This ensured that the device meets the dropout specifications even for maximum load current and a VIN of –3.2 V with only a modest increase in quiescent current. Quiescent current is always less than 350 uA, with the charge pump enabled. The quiescent current of the UCC384 does not increase with load current.

Short-circuit current is internally limited. The device responds to a sustained overcurrent condition by turning off after a tON delay. The device then stays off for a period, tOFF, that is 40 times the tON delay. The device then begins pulsing on and off at the tON/tOFF duty cycle of 2.5%. This drastically reduces the power dissipation during short circuit such that heat sinking, if at all required, must only accommodate normal operation. An external capacitor sets the on time. The off time is always 40 times tON.

The UCCx84-x can be shutdown to 45 uA (maximum) by pulling the SD/CT pin more positive than –0.7 V. To allow for simpler interfacing, the SD/CT pin may be pulled up to 6 V above the ground pin without turning on clamping diodes.

Internal power dissipation is further controlled with thermal-overload protection circuitry. Thermal shutdown occurs if the junction temperature exceeds 140°C. The chip remains off until the temperature has dropped 20°C (TJ = 120°C).

产品特性

Precision Negative Series Pass Voltage Regulation
0.2 V Dropout at 0.5 A
Wide Input Voltage Range –3.2 V to –15 V
Low Quiescent Current Irrespective of Load
Simple Logic Shutdown Interfacing
–5 V, –12 V, and Adjustable Output
2.5% Duty Cycle Short Circuit Protection

下面可能是您感兴趣的TI德州仪器公司单通道LDO元器件

TI公司产品现货专家，订购TI公司产品不限最低起订量，TI芯片大陆现货即时发货，香港库存3-5天发货，海外库存7-10天发货

寻找全球TI代理商现货货源 - TI公司（德州仪器）电子元件在线订购