The UCD30xx devices are members of a family of digital PWM controllers from Texas Instruments providing a single-chip control solution for digital power-conversion applications. These devices allow digital control implementation of a high-performance, high-frequency power supply with flexible configuration of parameters, supervisory, monitoring, and communication functions.

The UCD30xx are fully programmable solutions that are configurable to support a wide range of isolated and non-isolated topologies in single- or multiphase configurations. Some examples include interleaved PFC, isolated forward, half-bridge, phase-shifted full bridge, active clamp, and resonant LLC.

At the core of the UCD30xx controllers are the digital control-loop peripherals, also known as Fusion Digital Power peripherals (FDPP). Each FDPP implements a high-speed digital control loop consisting of a dedicated error analog-to-digital converter (EADC), a three-pole/three-zero (3p, 3z) digital compensator, and two DPWM outputs with 250-ps pulse-width resolution. The device also contains a 12-bit, 200-ksps general-purpose ADC with up to 15 channels, timers, interrupt controls, and communications ports such as PMBus, SCI, and SPI. The device is based on a 32-bit ARM7 RISC CPU that performs real-time monitoring, configures peripherals, and manages communications. The CPU executes its program out of programmable flash memory as well as ROM.

The UCD30xx is supported by Texas Instruments' Code Composer Studio software development environment.

Digital Control of up to Four Voltage Feedback Loops

Up to Eight High-Resolution Digital Pulsewidth Modulated (DPWM) Outputs for Supporting a Wide Range of Offline, Isolated and Non-Isolated DC-to-DC Topologies

• 250-ps DPWM Pulse-Width Resolution
• 4-ns DPWM Frequency Resolution
• Adjustable Phase Shift Between DPWM Outputs
• Adjustable Dead Band Between Each DPWM Pair
• Active-High or -Low DPWM Polarity
• Up to 2-MHz DPWM Switching Frequency

Dedicated High-Speed Error Analog-to-Digital Converter (EADC) for Each Feedback Loop With Sense Resolution of up to 1 mV

On-Chip 10-Bit D and A Converter (DAC) for Setting EADC Reference Voltage

Dedicated Hardware Accelerated Digital Compensators or Control Law Accelerators (CLA)

• Three-Pole, Three-Zero Configurable Compensator
• Features Non-Linear Digital Control
• Multiple Programmable Coefficient Registers for Adaptive Digital Compensation

Up to 15-Channel, 12-Bit, 200-ksps, Analog-to-Digital Converter (ADC)

Multiple Levels of Fault Protection

• Four High-Speed Analog Comparators
• External Fault Inputs
• 12-Bit ADC

Configurable for Voltage-Mode, Average-Current-Mode, and Resonant-Mode Control

Allows Synchronization of DPWM Waveforms Between Multiple UCD3040, UCD3020 and UCD3028 (UCD30xx) Devices

Adjustable DPWM Pulse Width Enables Support for Current Balancing in a Multiphase Application.

High-Performance 31.25-MHz, 32-Bit ARM7 Processor

32-KByte Program Flash and 2-KByte Data Flash Memory With Error Correction Code (ECC)

4-KByte Data RAM

4-KByte Boot ROM

Communication Peripherals

• PMBus
• UART
• SPI
• JTAG (Not Available in the UCD3028)

Single-Supply Solution: Internal Regulator Controls External Pass Element

Internal Temperature Sensor

Up to Five Additional Timers

Built-In Watchdog, BOD, and POR

80-Pin QFP (PFC), 64-Pin QFN (RGC), 48-Pin QFN (RGZ), and 40-Pin QFN (RHA and RMH) Package Offerings

Operating Temperature Range: –40°C to 125°C

APPLICATIONS

• Isolated AC-to-DC and DC-to-DC Power Supplies
• Power-Factor Correction
• Non-Isolated DC-to-DC Power Supplies

SN74AHC139 - 二路 2 线路到 4 线路解码器/多路解复用器

UCC27200-Q1 - 汽车类 120V 升压 3A 峰值电流的高频高端/低端驱动器

TPS62143 - 采用 3x3 QFN 封装的 3-17V 2A 降压转换器

TMS320VC5501 - 定点数字信号处理器

TM4C1233H6PZ - Tiva C 系列微控制器

LM4880 - 具有停机模式的双路 200 mW 音频功率放大器

74ACT11286 - 具有总线驱动器奇偶校验 I/O 端口的 9 位奇偶校验发生器/校验器

UCC284-5 - 单输出 LDO、500mA、固定电压 (5V)、低静态电流、宽输入电压范围

SN74LS629 - 双电压控制震荡器

SN74ALS86 - 四路 2 输入异或门