

- SN74AHCT573PW - 集成电路(IC) > 逻辑 > 锁存器
- INA296B1IDR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS77350DGKR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TM4C1231H6PMI7R - 集成电路(IC) > 嵌入式 > 微控制器
- TM4C123BH6PZI7R - 集成电路(IC) > 嵌入式 > 微控制器
- TPS22971YZPR - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- BQ29440DRBR - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- LMH6643MA/NOPB - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LMR23615EVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- LM2587T-5.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- CC1070EM-868 - 射频评估和开发套件,开发板
- TMS320C209PN57 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- TMS320VC549GGU-120 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- TLC2272CDG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS659114A2ZRCT - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- SN74LVC828ADW - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- SN74AHCT138PW - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- CD74HC04MT - 集成电路(IC) > 逻辑 > 门和反相器
- XAM3359ZCZ - 集成电路(IC) > 嵌入式 > 微处理器
- LM43603DSUR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器



BQ2003 - 具有负 dV 和 dT/dt 终端的镍镉电池/镍氢电池开关模式充电管理 IC
BQ2003是TI德州仪器公司的一款电池充电器IC产品,BQ2003是具有负 dV 和 dT/dt 终端的镍镉电池/镍氢电池开关模式充电管理 IC,本站介绍了BQ2003的封装应用图解、特点和优点、功能等,并给出了与BQ2003相关的TI元器件型号供参考。
BQ2003 - 具有负 dV 和 dT/dt 终端的镍镉电池/镍氢电池开关模式充电管理 IC - 电池充电器IC - 电池管理产品 - 德州仪器
The bq2003 Fast Charge IC provides comprehensive fast charge control functions together with high-speed switching power control circuitry on a monolithic CMOS device.
Integration of closed-loop current control circuitry allows the bq2003 to be the basis of a cost-effective solution for stand-alone and system-integrated chargers for batteries of one or more cells.
Switch-activated discharge-before-charge allows bq2003-based chargers to support battery conditioning and capacity determination.
High-efficiency power conversion is accomplished using the bq2003 as a hysteretic PWM controller for switch-mode regulation of the charging current. The bq2003 may alternatively be used to gate an externally regulated charging current.
Fast charge may begin on application of the charging supply, replacement of the battery, or switch depression. For safety, fast charge is inhibited unless/until the battery temperature and voltage are within configured limits.
Temperature, voltage, and time are monitored throughout fast charge. Fast charge is terminated by any of the following: Rate of temperature rise (t) Negative delta voltage (-V) Maximum voltage Maximum temperature Maximum time
After fast charge, an optional top-off phase is available. Constant-current maintenence charge is provided by an external trickle resistor.
- Fast charge and conditioning of nickel cadmium or nickel-metal hydride batteries
- Hysteretic PWM switch-mode current regulation or gated control of an external regulator
- Easily integrated into systems or used as a stand-alone charger
- Pre-charge qualification of temperature and voltage
- Direct LED outputs display battery and charge status
- Fast-charge termination by V, maximum voltage, maximum temperature, and maximum time
- Optional top-off charge
- OMAPL138B-EP - 增强型产品低功耗应用处理器
- OPA365-Q1 - 汽车类 2.2V、50MHz 低噪声单电源轨到轨运算放大器
- CD74HC4511 - 高速 CMOS 逻辑 BCD 至 7 段锁存器/解码器/驱动器
- CSD19534Q5A - 100V、N 通道 NexFET 功率 MOSFET,CSD19534Q5A
- REF2030 - 双输出 Vref 和 Vref/2 电压参考
- TPS3806I33-Q1 - 具有可调湿滞功能的汽车类、双路电压检测器
- LP2951-33-Q1 - 汽车单路输出 LDO、100mA、固定电压 (3.3V)、宽输入电压范围、复位标志
- MSP430F6723A - MSP430F673xA、MSP430F672xA 混合信号微控制器
- SN74CBTK32245 - 具有有源钳位下冲保护电路的 32 位 FET 总线开关
- CD54HC08 - 高速 CMOS 逻辑四路 2 输入与门



