

- LMR33630ADDAEVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- TLV0834CD - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- SN74LVC2G32DCT3 - 集成电路(IC) > 逻辑 > 门和反相器
- SN74ACT245WRKSRQ1 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- DS92LV18TVV/NOPB - 集成电路(IC) > 接口 > 串行器,解串器
- LP2981A-30DBVT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- PTN78060WAST - 板安装电源 > 直流转换器
- LM22673TJ-5.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- LMV774MTX - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- VC5501LMPGF300 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- MC3487NS - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TLC549ID - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- HVDA1040AQDSJRQ1 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- PT6881C - 板安装电源 > 直流转换器
- LM2832XMYX - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- ADS7951SDBT - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- LAUNCHXL-F2800157 - 开发板,套件,编程器 > 评估板 > 嵌入式 MCU、DSP 评估板
- TPS51116RGET - 集成电路(IC) > 电源管理(PMIC) > 特殊用途稳压器
- TMS320C6747AZKB3 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- TSC2302IRGZ - 集成电路(IC) > 数据采集 > 触摸屏控制器



CD4047B - CMOS 低功耗单稳态/不稳定多谐振荡器
CD4047B是TI德州仪器公司的一款单稳多频振荡器产品,CD4047B是CMOS 低功耗单稳态/不稳定多谐振荡器,本站介绍了CD4047B的封装应用图解、特点和优点、功能等,并给出了与CD4047B相关的TI元器件型号供参考。
CD4047B - CMOS 低功耗单稳态/不稳定多谐振荡器 - 单稳多频振荡器 - 特殊逻辑 - 德州仪器
CD4047B consists of a gatable astable multivibrator with logic techniques incorporated to permit positive or negative edge-triggered monostable multivibrator action with retriggering and external counting options.
Inputs include +TRIGGER, -TRIGGER, ASTABLE, ASTABLE\, RETRIGGER, and EXTERNAL RESET. Buffered outputs are Q\, Q and OSCILLATOR. In all modes of operation, and external capacitor must be connected between C-Timing and RC-Common terminal, and an external resistor must be connected between the R-Timing and RC-Common terminals.
Astable operation is enabled by a high level on the STABLE input or a low level on the ASTABLE\ input, or both. The period of the square wave at the Q and Q\ Outputs in this mode off operation is a function of the external components employed. "True" input pulses on the ASTABLE input or "Complement" pulses on the ASTABLE\ input allow the circuit to be used as a gatable multivibrator. The OSCILLATOR output period will be half of the Q terminal output in the astable mode. However, a 50% duty cycle is not guaranteed at this output.
The CD4047B triggers in the monostable mode when a positive-going edge occurs on the +TRIGGER-input while the -TRIGGER is held low. INput pulses may be of any duration relative to the output pulse.
If retrigger capability is desired, the RETRIGGER input is pulsed. The retriggerable mode of operation is limited to positive-going edge. The CD4047B will retrigger as long as the RETRIGGER-input is high, with or without transitions (See Fig. 34).
An external countdown option can be implemented by coupling "Q" to an external "N" counter and resetting the counter with the trigger pulse. The counter output pulse is fed back to the ASTABLE\ input and has a duration equal to N times the period of the multivibrator.
A high level on the EXTERNAL RESET input assures no output pulse during an "ON" power condition. This input can also be activated to terminate the output pulse at any tine. For monostable operation, whenever VDD is applied, and internal power-on reset circuit will clock the Q output low within one output period (tM).
The CD4047B-Series types are supplied in 14-lead hermetic dual-in-line ceramic packages (F3A suffix), 14-lead dual-in-line plastic packages (E suffix), 14-lead small outline packages (M, MT, M96, and NSR suffixes), and 14-lead thin shrink small-outline packages (PW and PWR suffixes).
- Lower power consumption: special CMOS oscillator configuration
- Monostable (one-shot) or astable (free-running) operation
- True and complemented buffered outputs
- Only one external R anc C required
- Buffered inputs
- 100% tested for quiescent current at 20 V
- Standardized, symmetrical output characteristics
- 5-V, 10-V, and 15-V parametric ratings
- Meets all requirements of JEDEC Tentative Standard No. 13B, "Standard Specifications for Description of 'B' Series CMOS Devices"
- Monostable Multivibrator Features:
- Positive-or negative-edge trigger
- Output pulse width independent of trigger pulse duration
- Retriggerable option for pulse width expansion
- Internal power-on reset circuit
- Long pulse widths possible using small RC components by means of external counter provision
- Fast recovery time essentially independent of pulse width
- Pulse-width accuracy maintained at duty cycles approaching 100%
- Astable Multivibrator Features:
- Free-running or gatable operating modes
- 50% duty cycle
- Oscillator output available
- Good astable frequency stability: Frequency deviation: = ±2% + 0.03%/°C @ 100 kHz = ±0.5% +0.015%/°C @ 10 kHz (circuits "trimmed" to frequency VDD = 10 V ± 10%)
- Applications: Digital equipment where low-power dissipation and/or high noise immunity are primary design requirements:
- Envelope detection
- Frequency multiplication
- Frequency division
- Frequency discriminators
- Timing circuits
- Time-delay applications
Data sheet acquired from Harris Semiconductor
- ADS8517 - 16-Bit 150-KSPS Low Power Sampling ADC w/Internal Ref & Parallel/Serial Interfac
- TLC555M - 低功耗 LinCMOS 定时器
- LM2704 - 具有 550mA 峰值电流限制的微功耗升压 DC/DC 转换器]]
- SN74ACT564 - 具有三态输出的八路 D 类边沿触发器
- ONET8551T - 具有 RSSI 的 11.3Gbps 限幅互阻抗放大器
- TPS60120 - 稳压 3.3V 高功率充电泵 DC/DC 转换器
- TLV1117LV - 1A 固定正电压低压降稳压器
- CDCEL937-Q1 - 具有 1.8V LVCMOS 输出的汽车类可编程 3-PLL VCXO 时钟合成器
- CY54FCT138T - 8 选 1 解码器
- ADS1112 - 16 位 240SPS ADC,2 通道 采用 MSOP-10 封装的差动/3 单端输入低功耗完整系统



