

- SN74AS153NSR - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- UCC38086P - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- CD74HC4520MT - 集成电路(IC) > 逻辑 > 计数器,除法器
- CD74HC688PW - 集成电路(IC) > 逻辑 > 比较器
- LM4992SDBD - 开发板,套件,编程器 > 评估板 > 音频放大器评估板
- SN74LVC1G32QDBVRQ1 - 集成电路(IC) > 逻辑 > 门和反相器
- TUSB2E2211001YCGR - 集成电路(IC) > 接口 > 信号缓冲器、中继器、分离器
- CLVC2G101WBQBRQ1 - 集成电路(IC) > 逻辑 > 触发器
- OPA4991IPWR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- PT6675F - 直流转换器
- UCC37324DGN - 集成电路(IC) > 电源管理(PMIC) > 栅极驱动器
- SN74CB3Q3257PWRG4 - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- TPS65175CRSHR - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- LOG200RGTT - 集成电路(IC) > 线性 > 放大器 > 特殊用途放大器
- TMP105YZCT - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- MSP430F2618TGQWTEP - 集成电路(IC) > 嵌入式 > 微控制器
- MPY634KUE4 - 集成电路(IC) > 线性 > 模拟乘法器、除法器
- TPSM84209RKHR - 板安装电源 > 直流转换器
- SN74HC21NE4 - 集成电路(IC) > 逻辑 > 门和反相器
- TPS7330QDG4 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性



CD74HC221 - 具有复位功能的高速 CMOS 逻辑双路单稳多频振荡器
CD74HC221是TI德州仪器公司的一款单稳多频振荡器产品,CD74HC221是具有复位功能的高速 CMOS 逻辑双路单稳多频振荡器,本站介绍了CD74HC221的封装应用图解、特点和优点、功能等,并给出了与CD74HC221相关的TI元器件型号供参考。
CD74HC221 - 具有复位功能的高速 CMOS 逻辑双路单稳多频振荡器 - 单稳多频振荡器 - 特殊逻辑 - 德州仪器
The HC221 and CD74HCT221 are dual monostable multivibrators with reset. An external resistor (RX) and an external capacitor (CX) control the timing and the accuracy for the circuit. Adjustment of RX and CX provides a wide range of output pulse widths from the Q and Q\ terminals. Pulse triggering on the B input occurs at a particular voltage level and is not related to the rise and fall time of the trigger pulse.
Once triggered, the outputs are independent of further trigger inputs on A\ and B. The output pulse can be terminated by a LOW level on the Reset (R)\ pin. Trailing Edge triggering (A)\ and leading-edge-triggering (B) inputs are provided for triggering from either edge of the input pulse. On power up, the IC is reset. If either Mono is not used each input (on the unused device) must be terminated either high or low.
The minimum value of external resistance, RX, is typically 500. The minimum value of external capacitance, CX, is 0pF. The calculation for the pulse width is tW = 0.7 RXCX at VCC = 4.5V.
- Overriding RESET Terminates Output Pulse
- Triggering from the Leading or Trailing Edge
- Q and Q\ Buffered Outputs
- Separate Resets
- Wide Range of Output-Pulse Widths
- Schmitt Trigger on B Inputs
- Fanout (Over Temperature Range)
- Standard Outputs . . . . 10 LSTTL Loads
- Bus Driver Outputs . . . . 15 LSTTL Loads
- Wide Operating Temperature Range . . . 55°C to 125°C
- Balanced Propagation Delay and Transition Times
- Significant Power Reduction Compared to LSTTL Logic ICs
- HC Types
- 2V to 6V Operation
- High Noise Immunity: NIL = 30%, NIH = 30% of VCC at VCC = 5V
- HCT Types
- 4.5V to 5.5V Operation
- Direct LSTTL Input Logic Compatibility, VIL = 0.8V (Max), VIH = 2V (Min)
- CMOS Input Compatibility, Il 1µA at VOL, VOH
Data sheet acquired from Harris Semiconductor
- CD74AC139 - 双路 2 至 4 线路解码器/多路解复用器
- DS90LV019 - 3.3V 或 5V LVDS 驱动器/接收器
- SN65LVPE801 - SN65LVPE801DRF
- SN54HC174 - 具有清零功能的六路 D 类触发器
- TL16C754B - 具有 64 字节 FIFO 的四路 UART
- CSD13306W - CSD13306W 12V N 通道 NexFET? 功率 MOSFET
- SN74ALS00A - 四路 2 输入正与非门
- SN74ALVCH16601 - 具有三态输出的 18 位通用总线收发器
- LM3475 - 滞后 PFET 降压控制器
- OPA1612 - 1.1nV/√Hz 噪声、低功耗、精密音频运算放大器



