CDCVF2509 - 3.3V 锁相环时钟驱动器

CDCVF2509是TI德州仪器公司的一款SDR产品，CDCVF2509是3.3V 锁相环时钟驱动器，本站介绍了CDCVF2509的封装应用图解、特点和优点、功能等，并给出了与CDCVF2509相关的TI元器件型号供参考。

CDCVF2509 - 3.3V 锁相环时钟驱动器 - SDR - 存储器接口时钟和寄存器 - 德州仪器

产品描述

The CDCVF2509 is a high-performance, low-skew, low-jitter, phase-lock loop (PLL) clock driver. It uses a PLL to precisely align, in both frequency and phase, the feedback (FBOUT) output to the clock (CLK) input signal. It is specifically designed for use with synchronous DRAMs. The CDCVF2509 operates at a 3.3-V VCC. It also provides integrated series-damping resistors that make it ideal for driving point-to-point loads.

One bank of five outputs and one bank of four outputs provide nine low-skew, low-jitter copies of CLK. Output signal duty cycles are adjusted to 50%, independent of the duty cycle at CLK. Each bank of outputs is enabled or disabled separately via the control (1G and 2G) inputs. When the G inputs are high, the outputs switch in phase and frequency with CLK; when the G inputs are low, the outputs are disabled to the logic-low state.

Unlike many products containing PLLs, the CDCVF2509 does not require external RC networks. The loop filter for the PLL is included on-chip, minimizing component count, board space, and cost.

Because it is based on PLL circuitry, the CDCVF2509 requires a stabilization time to achieve phase lock of the feedback signal to the reference signal. This stabilization time is required following power up and application of a fixed-frequency, fixed-phase signal at CLK, and following any changes to the PLL reference or feedback signals. The PLL can be bypassed by strapping AVCC to ground.

The CDCVF2509A is characterized for operation from 0°C to 85°C.

产品特性

Use CDCVF2509A (SCAS765) as a Replacement for This Device
Designed to Meet and Exceed PC133 SDRAM Registered DIMM Specification Rev. 1.1
Spread Spectrum Clock Compatible
Operating Frequency 50 MHz to 175 MHz
Static Phase Error Distribution at 66 MHz to 166 MHz Is ±125 ps
Jitter (cyc - cyc) at 66 MHz to 166 MHz Is Typ = 70 ps
Advanced Deep Submicron Process Results in More Than 40% Lower Power Consumption Versus Current Generation PC133 Devices
Available in Plastic 24-Pin TSSOP
Phase-Lock Loop Clock Distribution for Synchronous DRAM Applications
Distributes One Clock Input to One Bank of Five and One Bank of Four Outputs
Separate Output Enable for Each Output Bank
External Feedback (FBIN) Terminal Is Used to Synchronize the Outputs to the Clock Input
25- On-Chip Series Damping Resistors
No External RC Network Required
Operates at 3.3 V
APPLICATIONS
- DRAM Applications
- PLL Based Clock Distributors
- Non-PLL Clock Buffer

下面可能是您感兴趣的TI德州仪器公司SDR元器件

TI公司产品现货专家，订购TI公司产品不限最低起订量，TI芯片大陆现货即时发货，香港库存3-5天发货，海外库存7-10天发货

寻找全球TI代理商现货货源 - TI公司（德州仪器）电子元件在线订购