

- LMP7715MFX/NOPB - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- CD74HC08M96 - 集成电路(IC) > 逻辑 > 门和反相器
- MSP430F6724IPN - 集成电路(IC) > 嵌入式 > 微控制器
- SN74LV373AIPWRQ1 - 集成电路(IC) > 逻辑 > 锁存器
- INA2143UA/2K5G4 - 集成电路(IC) > 线性 > 放大器 > 特殊用途放大器
- LP2901N - 集成电路(IC) > 线性 > 比较器
- LM5175QPWPTQ1 - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- LP311DR - 集成电路(IC) > 线性 > 比较器
- SN74AUP1G00YFPR - 集成电路(IC) > 逻辑 > 门和反相器
- TLK6201EAMRGTT - 未分类 > 未分类
- SN74LVC16646ADGGR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- AMC1306EVM - 开发板,套件,编程器 > 评估板 > 模数转换器(ADC)评估板
- PC16550DV/NOPB - 集成电路(IC) > 接口 > UART(通用异步接收器发送器)
- SN74LVCR162245DL - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TLV27L2CDGK - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LM385BPWR-1-2 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- LP5996SD-2828 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TMX5700914PGEQQ1 - 集成电路(IC) > 嵌入式 > 微控制器
- SN74CBT16244DGGR - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- SN74LV175ADR - 集成电路(IC) > 逻辑 > 触发器



EMB1499Q - EMB1499Q 双向电流 DC/DC 控制器
EMB1499Q是TI德州仪器公司的一款电池监控,保护及认证解决方案产品,EMB1499Q是EMB1499Q 双向电流 DC/DC 控制器,本站介绍了EMB1499Q的封装应用图解、特点和优点、功能等,并给出了与EMB1499Q相关的TI元器件型号供参考。
EMB1499Q - EMB1499Q 双向电流 DC/DC 控制器 - 电池监控,保护及认证解决方案 - 电池管理产品 - 德州仪器
The EMB1499Q bidirectional current dc/dc controller IC works in conjunction with the EMB1428 switch matrix gate driver IC to support TI’s switch matrix based active cell balancing scheme for a battery management system. The EMB1499Q provides three PWM MOSFET gate signals to a bidirectional forward converter so that its output current, either positive or negative, is regulated around a user-defined magnitude. This inductor current is channeled by the EMB1428 through the switch matrix to the cell that needs to be charged or discharged. In a typical scheme, the EMB1499Q-based forward converter exchanges energy between a single cell and the battery stack to which it belongs, with a maximum stack voltage of up to 60 V. The switching frequency is fixed at 250 kHz. The EMB1499Q senses cell voltage, inductor current and stack current and provides protection from abnormal conditions during balancing.
The EMB1499Q also provides an active clamp timing signal to control an external FET driver for the primary-side active clamp FET. The EMB1499Q is enabled and disabled by the EMB1428. Fault conditions detected by the EMB1499Q are communicated to the EMB1428 through the DONE and FAULT pins.
- 60-V Maximum Stack Operating Voltage
- Bidirectional Balancing Current
- Fully Synchronous Operation
- Active Clamp Signal
- 250-kHz Switching Frequency
- Fault Detection Includes Two Separate UVLO Cells (One for Each External Supply), Primary and Secondary Side Current Limit, OVP/UVP Sense on Cell Being Charged, Thermal Shutdown, and Watchdog Timer
- Balancing Current User-selectable Through External Voltage
- EMB1499Q is an Automotive Grade Product that is AEC-Q100 Grade 1 Qualified (–40°C to +125°C Operating Junction Temperature)
- DS90CR287 - +3.3V 上升沿数据选通 LVDS 28 位频道链接发送器 - 85 MHz
- LP2981A-33 - 具有关断状态的 100mA 超低压降稳压器,0.75% 容差]]
- TPS62000-HT - 高温高效降压低功耗 DC-DC 转换器
- SN74LVC2G66 - 双模拟开关
- MSP430F47176 - 16 位超低功耗微控制器,具有 92KB 闪存、8KB RAM、6 个 Σ-Δ ADC 和 LCD 驱动器
- SN74ABT8996 - 10 位可寻址扫描端口,多点可寻址 IEEE 标准 1194.1 (JTAG) TAP 收发器
- LM3489-Q1 - 具有使能引脚的汽车级、4.5-35V、滞后非同步 PFET 降压控制器
- SN54ACT374 - 具有三态输出的八路 D 类边沿触发触发器
- TCA9546A - 具有复位功能的 1.655.5V 4 通道 I2C 和 SMBus 开关
- SN65MLVD3 - Single M-LVDS Receivers



