

- TPS628301ARZER - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- DS75176BTM - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- UCC561DPTRG4 - 接口 - 信号端接器
- ADS7890IPFBRG4 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- SN74LVC2G14YZPR - 集成电路(IC) > 逻辑 > 门和反相器
- UC3825BN - 集成电路(IC) > 电源管理(PMIC) > AC DC 转换器,离线开关
- INA790BEVM - 开发板,套件,编程器 > 评估板 > 运算放大器评估板
- LM4890MMX/NOPB - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- LP3981IMM-2.83/NOPB - 电源管理IC - 稳压器 - 线性
- LMH6658MA - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74LV8T374MPWREP - 集成电路(IC) > 逻辑 > 触发器
- TLV2464IN - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- DAC8551IDGKR - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- TMS320DM6433ZDU5 - 嵌入式 - DSP(数字信号处理器)
- LP2992IM5-3.0 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TS5MP646YFPR - 集成电路(IC) > 接口 > 模拟开关,多路复用器,解复用器
- 33P3721-CGTJ - 集成电路(IC) > 接口 > 专用
- LP2954AIS/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM4041CILPR - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- SN74AHC1GU04DCKR - 集成电路(IC) > 逻辑 > 门和反相器



LM5025C - 有源钳位电压模式 PWM 控制器
LM5025C是TI德州仪器公司的一款PWM与谐振控制器产品,LM5025C是有源钳位电压模式 PWM 控制器,本站介绍了LM5025C的封装应用图解、特点和优点、功能等,并给出了与LM5025C相关的TI元器件型号供参考。
LM5025C - 有源钳位电压模式 PWM 控制器 - PWM与谐振控制器 - 离线隔离型DC/DC控制器和转换器 - 德州仪器
The LM5025C is a functional variant of the LM5025 active clamp PWM controller. The functional differences of the LM5025C are: The maximum duty cycle of the LM5025C is increased from 80% to 91%. The soft-start capacitor charging current is increased from 20 µA to 90 µA. The VCC regulator current limit threshold is increased from 25 mA to 55 mA. The CS1 and CS2 current limit thresholds have been increased to 0.5V. The internal CS2 filter discharge device has been disabled and no longer operates each clock cycle. The internal VCC and VREF regulators continue to operate when the line UVLO pin is below threshold.
The LM5025C PWM controller contains all of the features necessary to implement power converters utilizing the Active Clamp / Reset technique. With the active clamp technique, higher efficiencies and greater power densities can be realized compared to conventional catch winding or RDC clamp / reset techniques. Two control outputs are provided, the main power switch control (OUT_A) and the active clamp switch control (OUT_B). The two internal compound gate drivers parallel both MOS and Bipolar devices, providing superior gate drive characteristics. This controller is designed for high-speed operation including an oscillator frequency range up to 1MHz and total PWM and current sense propagation delays less than 100 ns. The LM5025C includes a high-voltage start-up regulator that operates over a wide input range of 13V to 90V. Additional features include: Line Under Voltage Lockout (UVLO), softstart, oscillator UP/DOWN sync capability, precision reference and thermal shutdown.
- Internal Start-Up Bias Regulator
- 3A Compound Main Gate Driver
- Programmable Line Under-Voltage Lockout (UVLO) with Adjustable Hysteresis
- Voltage Mode Control with Feed-Forward
- Adjustable Dual Mode Over-Current Protection
- Programmable Overlap or Deadtime between the Main and Active Clamp Outputs
- Volt x Second Clamp
- Programmable Soft-start
- Leading Edge Blanking
- Single Resistor Programmable Oscillator
- Oscillator UP / DOWN Sync Capability
- Precision 5V Reference
- Thermal Shutdown
Package
- TSSOP-16
- LMP92001 - 用于模拟监控和控制的集成多通道 ADC 和 DAC
- LM2852 - 2A 500/1500kHz 同步 SIMPLE SWITCHER? 降压稳压器
- DRV8860 - 具有串行接口的八路低侧驱动器
- TPS54162-Q1 - 具有低 IQ、电压监控和复位功能的汽车类 1A、60V 降压 DC/DC 转换器
- ADS1174 - 四路 16 位同步采样模数转换器
- REF2912 - 采用 SOT23-3 系统封装的 1.25V 输出 100ppm/℃ 漂移 50uA 静态电流的(带隙)电压基准系列
- REF2030 - 双输出 Vref 和 Vref/2 电压参考
- SN74AHCT132 - 具有施密特触发器输入的四路正与非门
- LM5010A-Q1 - 针对汽车应用的 1A 宽输入电压降压开关稳压器
- ADC32J45 - ADC32J42 双通道 14 位 50 160 Msps 模数转换器



