

- SN74LVC3G07DCTRG4 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- DS99R124Q-EVK/NOPB - 评估和演示板及套件
- ADS4225EVM - 开发板,套件,编程器 > 评估板 > 模数转换器(ADC)评估板
- TPS79915DDCT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- ISO7421MDREP - 隔离器 > 数字隔离器
- ISO3080DW - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TPA3156D2EVM - 开发板,套件,编程器 > 评估板 > 音频放大器评估板
- LP3873ESX-1.8 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LT1004IPWR-2-5 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- UC2842DW - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- TMS320DM640ZDK400 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- TPS3124J12DBVR - 集成电路(IC) > 电源管理(PMIC) > 监控器
- TLV2401IDBVRG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- OPA404SG-BB - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LM340T-5.0/LB01 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- 74LVC1G123DCURG4 - 集成电路(IC) > 逻辑 > 多谐振荡器
- TPS7A7100RGWT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- ISO122JUG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- CD54HC10F3A - 集成电路(IC) > 逻辑 > 门和反相器
- LM3302D - 集成电路(IC) > 线性 > 比较器



LP3947 - USB/AC 适配器,单节锂离子电池充电器 IC
LP3947是TI德州仪器公司的一款电池充电器IC产品,LP3947是USB/AC 适配器,单节锂离子电池充电器 IC,本站介绍了LP3947的封装应用图解、特点和优点、功能等,并给出了与LP3947相关的TI元器件型号供参考。
LP3947 - USB/AC 适配器,单节锂离子电池充电器 IC - 电池充电器IC - 电池管理产品 - 德州仪器
The LP3947 is a complete charge management system that safely charges and maintains a Li-Ion battery from either USB power source or AC adaptor. In USB mode, the LP3947 supports charging in low power or high power mode. Alternatively, the LP3947 can take charge from AC adaptor. In both USB and AC adaptor modes, charge current, battery regulation voltage, and End of Charge (EOC) point can be selected via I2C interface. The LP3947 can also operate on default values that are pre-programmed in the factory. The battery temperature is monitored continuously at the Ts pin to safeguard against hazardous charging conditions. The charger also has under-voltage and over-voltage protection as well as an internal 5.6 hr timer to protect the battery. The pass transistor and charge current sensing resistor are all integrated inside the LP3947.
The LP3947 operates in four modes: pre-qualification, constant current, constant voltage and maintenance modes. There are two open drain outputs for status indication. An internal amplifier readily converts the charge current into a voltage. Also, the charger can operate in an LDO mode providing a maximum of 1.2 Amp to the load.
- Supports USB Charging Scheme
- Integrated Pass Transistor
- Near-Depleted Battery Preconditioning
- Monitors Battery Temperature
- Built-In 5.6 Hour Timer
- Under Voltage and Over Voltage Lockout
- Charge Status Indicators
- Charge Current Monitor Analog Output
- LDO Mode Operation can source 1 Amp
- Continuous Over Current/Temperature Protection
Key Specifications
- 1% Charger Voltage Accuracy Over 0°C ≤ TJ ≤ 85°C
- 4.3V to 6V Input Voltage Range
- 100 mA to 750 mA Charge Current Range, in Charger Mode
- 100 mA to 500 mA Charge Current Range, in USB Mode
- WSON Package Power Dissipation: 2.7W at TA = 25°C
- TLV704 - 24V 输入电压、150mA、超低IQ 低压降稳压器
- NS16C2552 - 具有 16 字节 FIFO 和高达 5 Mbit/s 数据速率的双路 UART
- CSD17575Q3 - 30V,N 通道 NexFET(TM) 功率 MOSFET
- TPA2029D1 - 具有 I2C 控制的立体声 D 类 APA
- TPS54325 - 4.5V 至 18V 输入、3A 同步降压 SWIFT? 转换器
- TPS22949 - 4.5V,0.2A,300mΩ,100mA 限流负载开关
- BQ27741-G1 - Pack-Side Impedance TrackT Fuel Gauge with Integrated Protector
- LMR14050-Q1 - 具有 40μA IQ 的汽车类 40V、5A SIMPLE SWITCHER、2.2MHz 降压稳压器
- TPS3420 - 具有可配置延迟的双通道按钮控制器
- ADS8512 - 具有 IR 和串行接口的 12 位 40KSPS 低功耗采样 A/D 转换器



