

- LP87702DRHBRQ1 - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- LM4985TMX/NOPB - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- MSP430G2432IPW20 - 集成电路(IC) > 嵌入式 > 微控制器
- TRSF3238CDWG4 - 接口 - 驱动器,接收器,收发器
- TPS75901KTTT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TMS320C6672ACYPA - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- CD74HC237M96G4 - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- TPS65581EVM-575 - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- THS6223IRHBR - 未分类 > 未分类
- AFE7988IABJ - 射频和无线 > 射频收发器 IC
- LM224KDE4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPA6112A2EVM - 开发板,套件,编程器 > 评估板 > 音频放大器评估板
- TPS76325DBVT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74S08D - 集成电路(IC) > 逻辑 > 门和反相器
- CD40194BPWG4 - 逻辑 - 移位寄存器
- LM70CILDX-5 - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- TPS7H5030EVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- TPS7B8850QKVURQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM4050QAIM3X2.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- TPS2044BD - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器



SN54ACT373-SP - 具有三态输出的八路 D 类透明锁存器
SN54ACT373-SP是TI德州仪器公司的一款D类锁存器产品,SN54ACT373-SP是具有三态输出的八路 D 类透明锁存器,本站介绍了SN54ACT373-SP的封装应用图解、特点和优点、功能等,并给出了与SN54ACT373-SP相关的TI元器件型号供参考。
SN54ACT373-SP - 具有三态输出的八路 D 类透明锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These 8-bit latches feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. The devices are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The eight latches are D-type transparent latches. When the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the logic levels set up at the D inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines in bus-organized systems without need for interface or pullup components.
(OE)\ does not affect the internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, (OE)\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
- 4.5-V to 5.5-V VCC Operation
- Inputs Accept Voltages to 5.5 V
- Max tpd of 10 ns at 5 V
- Inputs Are TTL-Voltage Compatible
- TPS54227 - 4.5V 至 18V 输入、2A 同步降压转换器
- DAC7611 - 12 位串行输入数模转换器
- UCC2805-Q1 - 汽车类低功耗 BiCMOS 电流模式 PWM
- ADS8343 - 16 位 4 通道串行输出采样模数转换器
- SN54HC165 - 并联负载 8 位移位寄存器
- SN75C1154 - 四路低功耗驱动器/接收器
- LMX2581E - LMX2581E 具有集成 VCO 的宽带频率合成器
- SN74AS808B - 六路 2 输入与驱动器
- SN74LVTH16500 - 具有三态输出的 3.3V CMOS 18 位通用总线收发器
- TPA3117D2 - 15W 立体声无滤波器 D 类放大器



