

- TLE2062CPSR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- AMC1204QDWRQ1 - 集成电路(IC) > 数据采集 > ADC/DAC - 特殊用途
- AMC0381R10DFXR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS2540RTET - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- LMR51435FNDRRR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- BQ78350DBTR-R1A - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- LM4840LQ/NOPB - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- SN74AS181ADWRE4 - 逻辑 - 专用逻辑
- TPS2097DR - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- EVM430-F6779 - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- SN74HC74QDRQ1 - 集成电路(IC) > 逻辑 > 触发器
- SN74LVT32244GKER - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TPS76850QPWPREP - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TLC277CP - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LP2989AIMX-2.5/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74LVC1G06DCKT - 集成电路(IC) > 逻辑 > 门和反相器
- SN74LS138D - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- TPS2330IDR - 集成电路(IC) > 电源管理(PMIC) > 热插拔控制器
- SN74AC245NSR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TPS62008DGSR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器



SN54S373 - 具有三态输出的八路 D 类透明锁存器
SN54S373是TI德州仪器公司的一款D类锁存器产品,SN54S373是具有三态输出的八路 D 类透明锁存器,本站介绍了SN54S373的封装应用图解、特点和优点、功能等,并给出了与SN54S373相关的TI元器件型号供参考。
SN54S373 - 具有三态输出的八路 D 类透明锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These 8-bit registers feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. The high-impedance 3-state and increased high-logic-level drive provide these registers with the capability of being connected directly to and driving the bus lines in a bus-organized system without need for interface or pullup components. These devices are particularly attractive for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The eight latches of the LS373 and S373 are transparent D-type latches, meaning that while the enable (C or CLK) input is high, the Q outputs follow the data (D) inputs. When C or CLK is taken low, the output is latched at the level of the data that was set up.
The eight flip-flops of the LS374 and S374 are edge-triggered D-type flip-flops. On the positive transition of the clock, the Q outputs are set to the logic states that were set up at the D inputs.
Schmitt-trigger buffered inputs at the enable/clock lines of the S373 and S374 devices simplify system design as ac and dc noise rejection is improved by typically 400 mV due to the input hysteresis. A buffered output-control (OC) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly.
OC\ does not affect the internal operation of the latches or flip-flops. That is, the old data can be retained or new data can be entered, even while the outputs are off.
- Choice of Eight Latches or Eight D-Type Flip-Flops in a Single Package
- 3-State Bus-Driving Outputs
- Full Parallel Access for Loading
- Buffered Control Inputs
- Clock-Enable Input Has Hysteresis to Improve Noise Rejection (S373 and S374)
- P-N-P Inputs Reduce DC Loading on Data Lines (S373 and S374)
- BQ4285E - RTC IC,具有 114x8 NVSRAM 和 NVSRAM 控制、针对 L 版本发出警报唤醒 3V 操作
- BQ25101H - 1A 单路输入、单节锂离子电池充电器
- ADS5287 - 8-Channel, 10-bit, 65MSPS Analog-to-Digital Converter
- TPS2816-EP - 增强型产品单路高速 MOSFET 驱动器
- TLK1211 - Gigabit Ethernet Serdes for PON
- LM12458 - 具有自校准功能的 12 位 + 数据采集系统]]
- LM2937-2.5 - 400mA and 500mA Voltage Regulator
- LMK04131 - Clock Jitter Cleaner with Cascaded PLLs
- TPS7A16 - 具有使能端和电源正常状态输出的 60V、5μA Iq、100mA、低压降电压稳压器
- SN74ABT16500B - 具有三态输出的 18 位通用总线收发器



