

- TPS2064CDGNR-2 - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- TL7705ACP - 集成电路(IC) > 电源管理(PMIC) > 监控器
- BQ25628ERYKR - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- OMAPL138BZCE4 - 集成电路(IC) > 嵌入式 > 微处理器
- SN74ALS805ADWR - 集成电路(IC) > 逻辑 > 门和反相器
- CC2650MODAMOHT - 射频和无线 > 射频收发器模块和调制解调器
- PCM1719E - 集成电路(IC) > 数据采集 > ADC/DAC - 特殊用途
- UC2543N - 集成电路(IC) > 电源管理(PMIC) > 电源控制器,监视器
- WAVEVSN BRD 5.1/NOPB - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- TPS2052BDGN - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- MSP430F1111AIDGV - 集成电路(IC) > 嵌入式 > 微控制器
- UC3836DTR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性稳压器控制器
- SN74HCT04DRG4 - 集成电路(IC) > 逻辑 > 门和反相器
- ADS9129RHAR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- MSP430F6746IPEU - 集成电路(IC) > 嵌入式 > 微控制器
- M38510/11904BPX - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS7A1130PDRVT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM25066APSQE/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- UCC3958PWP-3 - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- TLC5916IDG4 - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器



SN74ABT16373A - 具有三态输出的 16 位透明 D 类锁存器
SN74ABT16373A是TI德州仪器公司的一款D类锁存器产品,SN74ABT16373A是具有三态输出的 16 位透明 D 类锁存器,本站介绍了SN74ABT16373A的封装应用图解、特点和优点、功能等,并给出了与SN74ABT16373A相关的TI元器件型号供参考。
SN74ABT16373A - 具有三态输出的 16 位透明 D 类锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
The 'ABT16373A are 16-bit transparent D-type latches with 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. They are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
These devices can be used as two 8-bit latches or one 16-bit latch. When the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the levels set up at the D inputs.
A buffered output-enable (OE\) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or a high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and the increased drive provide the capability to drive bus lines without need for interface or pullup components.
OE\ does not affect internal operations of the latch. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
When VCC is between 0 and 2.1 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 2.1 V, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
The SN54ABT16373A is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74ABT16373A is characterized for operation from -40°C to 85°C.
- Members of the Texas Instruments WidebusTM Family
- State-of-the-Art EPIC-II BTM BiCMOS Design Significantly Reduces Power Dissipation
- Latch-Up Performance Exceeds 500 mA Per JEDEC Standard JESD-17
- Typical VOLP (Output Ground Bounce) < 0.8 V at VCC = 5 V, TA = 25°C
- High-Impedance State During Power Up and Power Down
- Distributed VCC and GND Pin Configuration Minimizes High-Speed Switching Noise
- Flow-Through Architecture Optimizes PCB Layout
- High-Drive Outputs (-32-mA IOH, 64-mA IOL)
- Package Options Include Plastic 300-mil Shrink Small-Outline (DL) and Thin Shrink Small-Outline (DGG) Packages and 380-mil Fine-Pitch Ceramic Flat (WD) Package Using 25-mil Center-to-Center Spacings
Widebus and EPIC-IIB are trademarks of Texas Instruments Incorporated.
- LM76 - 具有温度比较器和 I2C 接口的 ±1°C 温度传感器
- ADS8863 - 具有 18 位、333kSPS 和串行接口的微功耗小型差动输入
- TPS51367 - 具有集成 FET 的 22V 输入 12A ULQ(tm) DC/DC 转换器
- SN75C1154 - 四路低功耗驱动器/接收器
- DS25BR400 - 具有发送去加重功能和接收均衡的四路 2.5 Gbps CML 收发器
- BQ25100H - 1A 单路输入、单节锂离子电池充电器
- BQ2054 - 锂离子电池开关模式充电管理 IC
- TLV5638 - 12 位、1 或 3.5us DAC,具有串行输入、双路 DAC、可编程内部参考和稳定时间、功耗
- CD4053B - 具有逻辑电平转换功能的 CMOS 三路 2 通道模拟多路复用器/多路解复用器
- SN74ALS867A - 同步 8 位加/减二进制计数器



