

- BQ2000PWRG4 - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- PCM3060PWRG4 - 集成电路(IC) > 接口 > 编解码器
- TPS7A2033YCKR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- OPA2652U/2K5 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS65295RJET - 集成电路(IC) > 电源管理(PMIC) > 特殊用途稳压器
- LMK04000BEVAL/NOPB - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- SN74LVC574ANSR - 集成电路(IC) > 逻辑 > 触发器
- LP5951MGX-1.5 - 电源管理IC - 稳压器 - 线性
- TPS7A4501EVM-385 - 开发板,套件,编程器 > 评估板 > 线性稳压器评估板
- TPS2043AD - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- LM1770EVAL - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- SN74S74N - 集成电路(IC) > 逻辑 > 触发器
- LM5169FNGUR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- SN74ALS540DW - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- ADS1226IRGVT - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- SN74V273-7PZA - 集成电路(IC) > 逻辑 > FIFO 存储器
- PT6606E - 板安装电源 > 直流转换器
- DAC60508ZYZFT - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- SN65MLVD200ADRG4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- ADS1230REF - 开发板,套件,编程器 > 评估板 > 模数转换器(ADC)评估板



UC3906 - 铅酸线性充电管理 IC
UC3906是TI德州仪器公司的一款电池充电器IC产品,UC3906是铅酸线性充电管理 IC,本站介绍了UC3906的封装应用图解、特点和优点、功能等,并给出了与UC3906相关的TI元器件型号供参考。
UC3906 - 铅酸线性充电管理 IC - 电池充电器IC - 电池管理产品 - 德州仪器
The UC2906 series of battery charger controllers contains all of the necessary circuitry to optimally control the charge and hold cycle for sealed lead-acid batteries. These integrated circuits monitor and control both the output voltage and current of the charger through three separate charge states; a high current bulk-charge state, a controlled over-charge, and a precision float-charge, or standby, state.
Optimum charging conditions are maintained over an extended temperature range with an internal reference that tracks the nominal temperature characteristics of the lead-acid cell. A typical standby supply current requirement of only 1.6mA allows these ICs to predictably monitor ambient temperatures.
Separate voltage loop and current limit amplifiers regulate the output voltage and current levels in the charger by controlling the onboard driver. The driver will supply up to 25mA of base drive to an external pass device. Voltage and current sense comparators are used to sense the battery condition and respond with logic inputs to the charge state logic. A charge enable comparator with a trickle bias output can be used to implement a low current turn-on mode of the charger, preventing high current charging during abnormal conditions such as a shorted battery cell.
Other features include a supply under-voltage sense circuit with a logic output to indicate when input power is present. In addition the over-charge state of the charger can be externally monitored and terminated using the over-charge indicate output and over-charge terminate input.
- Optimum Control for Maximum Battery Capacity and Life
- Internal State Logic Provides Three Charge States
- Precision Reference Tracks Battery Requirements Over Temperature
- Controls Both Voltage and Current at Charger Output
- System Interface Functions
- Typical Standby Supply Current of only 1.6mA
- TPS77601 - 单输出 LDO、500mA、可调节电压(1.2 至 5.5V)、快速瞬态响应、电源良好 (PG) 输出
- SN54HC03 - 具有漏极开路输出的四路 2 输入正与非门
- SN54AC02-SP - 四路 2 输入正与非门
- SN74LS221 - 具有施密特触发输入的双路单稳多频振荡器
- SM72295 - 光电全桥驱动器
- PCM5101A-Q1 - 具有 32 位、384kHz PCM 接口的 2VRMS DirectPath?、112/106/100dB 音频立体声 DAC
- CD4056B - 具有选通锁存功能的 CMOS BCD 到 7 段 LCD 解码器/驱动器
- LM2700 - 600kHz/1.25MHz、2.5A、升压 PWM DC/DC 转换器
- MSP430F5631 - MSP430F563x 混合信号微处理器
- SN54LS161A-SP - 同步 4 位计数器



