UC3914 - 5-35V 单路热插拔 IC 商用温度范围

UC3914是TI德州仪器公司的一款热插拔控制器（正48V)产品，UC3914是5-35V 单路热插拔 IC 商用温度范围，本站介绍了UC3914的封装应用图解、特点和优点、功能等，并给出了与UC3914相关的TI元器件型号供参考。

UC3914 - 5-35V 单路热插拔 IC 商用温度范围 - 热插拔控制器（正48V) - 保护、监控和热插拔 - 德州仪器

产品描述

The UC3914 family of hot swap power managers provides complete power management, hot swap and fault handling capability. Integrating this part and a few external components, allows a board to be swapped in or out upon failure or system modification without removing power to the hardware, while maintaining the integrity of the powered system. Complementary output drivers and diodes have been integrated for use with external capacitors as a charge pump to ensure sufficient gate drive to the external N-channel MOSFET transistor for low RDS(on). All control and housekeeping functions are integrated and externally programmable and include the fault current level, maximum output sourcing current, maximum fault time and average power limiting of the external FET. The UC3914 features a duty ratio current limiting technique, which provides peak load capability while limiting the average power dissipation of the external pass transistor during fault conditions. The fault level is fixed at 50 mV with respect to VCC to minimize total dropout.

The fault current level is set with an external current sense resistor. The maximum allowable sourcing current is programmed by using a resistor divider from VCC to REF to set the voltage on IMAX. The maximum current level, when the output appears as a current source is (VVCC – VIMAX)/RSENSE.

This part is offered in both 18-pin DW wide-body (SOIC) and dual-in-line (DIL) packages.

When the output current is less than the fault level, the external output transistor remains switched on. When the output current exceeds the fault level, but is less than the maximum sourcing level programmed by IMAX, the output remains switched on, and the fault timer starts to charge CT, a timing capacitor. Once CT charges to 2.5 V, the output device is turned off and CT is slowly discharged. Once CT is discharged to 0.5 V, the device performs a retry and the output transistor is switched on again. The UC3914 offers two distinct reset modes. In one mode with LR left floating or held low, the device tries to reset itself repeatedly if a fault occurs as described above. In the second mode with LR held high, once a fault occurs, the output is latched off until either LR is toggled low, the part is shutdown then re-enabled using SD\, or the power to the part is turned off and then on again.

产品特性

5V to 35V Operation
Precision Maximum Current Control
Precision Fault Threshold
Programmable Average Power Limiting
Programmable Overcurrent Limit
Shutdown Control
Charge Pump for Low RDS(on) High-Side Drive
Latch Reset Function Available
Output Drive VGS Clamping
Fault Output Indication
18 Pin DIL and SOIC Packages

下面可能是您感兴趣的TI德州仪器公司热插拔控制器（正48V)元器件

TI公司产品现货专家，订购TI公司产品不限最低起订量，TI芯片大陆现货即时发货，香港库存3-5天发货，海外库存7-10天发货

寻找全球TI代理商现货货源 - TI公司（德州仪器）电子元件在线订购