

- LM4041CIM3-ADJ - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- THS4226DGQ - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- BQ29411PWG4 - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- SN65LVDT388DBT - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- REG102NA-5/250 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS2013ADR - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- TLV4314IPWR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS65981EVM - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- LM9061M - 集成电路(IC) > 电源管理(PMIC) > 栅极驱动器
- THS4021ID - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- HDC1008YPAR - 传感器,变送器 > 湿度、湿敏传感器
- UC494J - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- TPS2070DAP - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- LM3S9781-IBZ80-C3 - 嵌入式 - 微控制器
- SN65HVD1792D - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- LP38841MRX-ADJ/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74LS38NS - 集成电路(IC) > 逻辑 > 门和反相器
- LP2997M/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- MSP430F6747IPEU - 集成电路(IC) > 嵌入式 > 微控制器
- SN74F657DWRE4 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器



74ACT16374 - 具有三态输出的 16 位 D 类边沿触发触发器
74ACT16374是TI德州仪器公司的一款D类触发器产品,74ACT16374是具有三态输出的 16 位 D 类边沿触发触发器,本站介绍了74ACT16374的封装应用图解、特点和优点、功能等,并给出了与74ACT16374相关的TI元器件型号供参考。
74ACT16374 - 具有三态输出的 16 位 D 类边沿触发触发器 - D类触发器 - 触发器/锁存器/寄存器 - 德州仪器
The SN54ACT16374 and 74ACT16374 are 16-bit edge-triggered D-type flip-flops with 3-state outputs designed specifically for driving highly-capacitive or relatively low-impedance loads. They are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
These devices can be used as two 8-bit flip-flops or one 16-bit flip-flop. On the positive transition of the clock (CLK) input, the Q outputs of the flip-flop take on the logic levels set up at the data (D) inputs.
An output-enable input (OE) can be used to place the outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state provides the capability to drive bus lines in a bus-organized system without need for interface or pullup components. OE does not affect the internal operations of the flip-flop. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
The 74ACT16374 is packaged in TIs shrink small-outline package, which provides twice the I/O pin count and functionality of standard small-outline packages in the same printed-circuit board area.
The SN54ACT16374 is characterized for operation over the full military temperature range of -55°C to 125°C. The 74ACT16374 is characterized for operation from -40°C to 85°C.
- Members of the Texas Instruments Widebus™ Family
- Inputs Are TTL-Voltage Compatible
- 3-State Bus-Driving True Outputs
- Flow-Through Architecture Optimizes PCB Layout
- Distributed Center-Pin VCC and GND Configurations Minimize High-Speed Switching Noise
- EPIC™ (Enhanced-Performance Implanted CMOS) 1-µm Process
- 500-mA Typical Latch-Up Immunity at 125°C
- Package Options Include Plastic 300-mil Shrink Small-Outline (DL) Packages Using 25-mil Center-to-Center Pin Spacings and 380-mil Fine-Pitch Ceramic Flat (WD) Packages Using 25-mil Center-to-Center Pin Spacings
EPIC and Widebus are trademarks of Texas Instruments Incorporated.
- SN74HC139-Q1 - 汽车类二路 2 线路至 4 线路解码器/解复用器
- BQ4285E - RTC IC,具有 114x8 NVSRAM 和 NVSRAM 控制、针对 L 版本发出警报唤醒 3V 操作
- UA78M08 - 3/4 引脚 500mA 固定 8V 正电压稳压器
- LM2703 - 具有 350mA 峰值电流限制的微功耗升压 DC/DC 转换器
- SN7432 - 四路 2 输入正或门
- MSP430F2274 - 16 位超低功耗微控制器,具有 32KB 闪存和 1K RAM
- SN74LV4053A-Q1 - 汽车类三路 2 通道模拟多路复用器/多路解复用器
- UCC27519A-Q1 - UCC27518A-Q1、UCC27519A-Q1 单通道高速低侧栅极驱动器
- ISO721M-EP - 增强型产品单路 150Mbps 数字隔离器
- LM3524D - 稳压脉宽调制器



