

- ISO100BP - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS65811RTQR - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- TLC5617AID - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- 66AK2H06AAAWA2 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- SN74ALVC14D - 集成电路(IC) > 逻辑 > 门和反相器
- SN74ALS157AD - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- DP8422VX-33 - 集成电路(IC) > 存储器 > 控制器
- XTR101APG4 - 集成电路(IC) > 接口 > 传感器和检测器接口
- LM9076BMAX-5.0 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- MSP430FR2032IG48 - 集成电路(IC) > 嵌入式 > 微控制器
- TPUL2T323PWR - 集成电路(IC) > 逻辑 > 多谐振荡器
- TL061ACP - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- ADC081C02XEB - 开发板,套件,编程器 > 评估板 > 模数转换器(ADC)评估板
- JFE2140DR - 分立半导体产品 > 晶体管 > JFET
- UCC27324DG4 - 集成电路(IC) > 电源管理(PMIC) > 栅极驱动器
- SN74LVC06APWT - 集成电路(IC) > 逻辑 > 门和反相器
- SN74ABT853NSRG4 - 逻辑 - 缓冲器,驱动器,接收器,收发器
- CDCEL824PWR - 集成电路(IC) > 时钟/定时 > 时钟发生器,PLL,频率合成器
- ADS8862IDRCR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- ADS7829IBDRBR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)



SN74AVCA164245 - 具有可配置电压转换和 3 态输出的 16 位双电源总线收发器
SN74AVCA164245是TI德州仪器公司的一款应用特定电压转换产品,SN74AVCA164245是具有可配置电压转换和 3 态输出的 16 位双电源总线收发器,本站介绍了SN74AVCA164245的封装应用图解、特点和优点、功能等,并给出了与SN74AVCA164245相关的TI元器件型号供参考。
SN74AVCA164245 - 具有可配置电压转换和 3 态输出的 16 位双电源总线收发器 - 应用特定电压转换 - 电压电平转换 - 德州仪器
This 16-bit (dual-octal) noninverting bus transceiver uses two separate configurable power-supply rails. The A-port is designed to track VCCA. VCCA accepts any supply voltage from 1.4 V to 3.6 V. The B-port is designed to track VCCB. VCCB accepts any supply voltage from 1.4 V to 3.6 V. This allows for universal low-voltage bidirectional translation between any of the 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes.
The SN74AVCA164245 is designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE)\ input can be used to disable the outputs so the buses are effectively isolated.
The SN74AVCA164245 is designed so that the control pins (1DIR, 2DIR, 1OE\, and 2OE\) are supplied by VCCA.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCCA through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. If either VCC input is at GND, then both ports are in the high-impedance state.
- Member of the Texas Instruments Widebus Family
- DOCCircuitry Dynamically Changes Output Impedance, Resulting in Noise Reduction Without Speed Degradation
- Dynamic Drive Capability Is Equivalent to Standard Outputs With IOH and IOL of ±24 mA at 2.5-V VCC
- Control Inputs VIH/VIL Levels are Referenced to VCCA Voltage
- If Either VCC Input Is at GND, Both Ports Are in the High-Impedance State
- Overvoltage-Tolerant Inputs/Outputs Allow Mixed-Voltage-Mode Data Communications
- Ioff Supports Partial-Power-Down Mode Operation
- Fully Configurable Dual-Rail Design Allows Each Port to Operate Over the Full 1.4-V to 3.6-V Power-Supply Range
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- 1000-V Charged-Device Model (C101)
DOC and Widebus are trademarks of Texas Instruments.
- DS90UH926Q-Q1 - 具有 HDCP 的 5 - 85 MHz 24 位彩色 FPD-Link III 解串器
- THS0842 - 8 位 40 MSPS ADC,具有双通道(配置)、双路同步采样和保持输入、低功耗和关断状态
- SN74CB3Q3253 - 双路 4 选 1 FET 多路复用器/多路解复用器,2.5V/3.3V 低电压高带宽总线开关
- ADS5282 - 8-Channel, 12-bit, 65MSPS Analog-to-Digital Converter
- BQ24115 - 采用 QFN 封装具有 2A FET 的 bqSWITCHER(TM) 同步开关模式锂离子充电器,1 节至 3 节系统控制版本
- TPS3421 - 具有可配置延迟和复位脉冲的双通道按钮控制器
- TPS2514A-Q1 - TPS2513A-Q1 USB 专用充电端口控制器
- TPS61175-Q1 - 3A 高压汽车类升压转换器,可编程开关频率为
- SN75454B - 二路非常高速大电流外设驱动器
- SMJ320F2812 - SM320F2812 Digital Signal Processor



