

- OPA251PA - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LP3892ET-1.5/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS3837J25DBVT - 集成电路(IC) > 电源管理(PMIC) > 监控器
- LM140LAH-5.0 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- MSP430F2370IRHAT - 集成电路(IC) > 嵌入式 > 微控制器
- LM3S1937-IBZ50-A2T - 集成电路(IC) > 嵌入式 > 微控制器
- LM3S5D51-IBZ80-A2T - 嵌入式 - 微控制器
- CD4053BQM96G4Q1 - 集成电路(IC) > 接口 > 模拟开关,多路复用器,解复用器
- SN74ABT646ADBR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- SN74LVCH16244AZQLR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- LM555CM - 集成电路(IC) > 时钟/定时 > 可编程定时器和振荡器
- 5962-8670403XA - 集成电路(IC) > 电源管理(PMIC) > 电源控制器,监视器
- BQ79631PAPRQ1 - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- MSP430F2111IPWR - 集成电路(IC) > 嵌入式 > 微控制器
- TPS63901EVM-100 - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- SN74CBT3345PW - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- DAC7553IRGTR - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- PT6603B - 板安装电源 > 直流转换器
- UA78L12ACD - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TSC2300IPAG - 集成电路(IC) > 数据采集 > 触摸屏控制器



UC37133 - 高侧智能功率开关
UC37133是TI德州仪器公司的一款智能功率开关产品,UC37133是高侧智能功率开关,本站介绍了UC37133的封装应用图解、特点和优点、功能等,并给出了与UC37133相关的TI元器件型号供参考。
UC37133 - 高侧智能功率开关 - 智能功率开关 - 集成负载开关 - 德州仪器
The UC37131, UC37132 and UC37133 are a family of smart power switches which can drive resistive or inductive loads from the high side or low side.
The UC37132 is available in 14 pin (DIP), 16 pin (SOIC), or 20 pin (CLCC) packages and can accommodate both low side (load to VCC) or high side (load to GND) configurations. The UC37131 and UC37133 are exclusively for a low side or a high side configuration respectively and both are available in an 8 pin package. Both high side and low side configurations provide high current switching with low saturation voltages which can drive resistive or inductive loads.
The input to the switch is driven by a low voltage signal, typically 5V. Additionally, UC37132 features adjustable hysteresis. The output of the device can switch a load between 8V and 65V. Output current capability is 300mA continuous or 700mA peak.
The device also has inherent smart features that allow for programmable turn-on delay in enabling the output following startup. The same capacitor that specifies the turn-on delay is also used to program a VCC power interruption time. If VCC drops below a threshold for a time specified by this capacitor, the output is turned off and a new turn-on delay will be retriggered. Similarly, if high current persists longer than the response delay, the output driver will operate in a very low duty cycle mode to protect the IC.
- 300mA Continuous Output Current
- Low Side or High Side Switch Configuration
- 8V to 65V Operation
- Overload and Short Circuit Protection
- Power Interruption Protection
- +6V Regulated Voltage
- 2mA Quiescent Current
- Programmable Overcurrent and Power Interruption Protection
- 1% to 30% Programmable Input Comparator Hysteresis (on UC37132)
- Low and High Side Internal High Current Clamps When Driving Inductive Loads
- SN74ABT18646 - 具有 18 位总线收发器和寄存器的扫描测试设备
- BQ24104 - 同步开关模式,锂离子和锂聚合物充电管理 IC (bqSwitcher)
- BQ24125 - 具有增强的 EMI 性能的单芯片开关模式、锂离子和锂聚合物充电管理 IC
- AM1802 - Sitara 处理器
- SN65LVDS388A - 八路 LVDS 接收器
- TPS3836K33-Q1 - 具有 10ms/200ms 可选择延迟时间的汽车类 220nA 监控器
- BQ24166 - 电池管理产品
- THS9000 - 50MHz 至 750MHz 级联放大器
- LP2996A - LP2996 DDR 终端稳压器
- SN54LS257B - 四路 2 线路到 1 线路数据选择器/多路复用器



