

- EVM430-F6736 - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- CSD18535KTTT - 分立半导体产品 > 晶体管 > FET,MOSFET > 单 FET,MOSFET
- PCM2902CDBR - 集成电路(IC) > 接口 > 编解码器
- THS6062CDRG4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- SN74AHCT123ADR - 集成电路(IC) > 逻辑 > 多谐振荡器
- TLC27M7CP - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LP2989IMX-3.0 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74ALS646A-1DWRG4 - 逻辑 - 缓冲器,驱动器,接收器,收发器
- DRV590GQCR - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- TPS3836H30DBVR - 集成电路(IC) > 电源管理(PMIC) > 监控器
- CD4503BE - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- CD74HCT173M - 集成电路(IC) > 逻辑 > 触发器
- TLV274IDG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SNJ54LS598J - 集成电路(IC) > 逻辑 > 移位寄存器
- SN74HCS273PWR - 集成电路(IC) > 逻辑 > 触发器
- LM395T/NOPB - 分立半导体产品 > 晶体管 > 双极(BJT) > 单双极晶体管
- CD74HCT241M - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- CD74HCT02MT - 集成电路(IC) > 逻辑 > 门和反相器
- LMH6720MAX-NS - 集成电路(IC) > 线性 > 放大器 > 视频放大器和模块
- SN74ABT821ANT - 集成电路(IC) > 逻辑 > 触发器



UCC2808A-2Q1 - 汽车类低功耗电流模式推挽 PWM
UCC2808A-2Q1是TI德州仪器公司的一款PWM与谐振控制器产品,UCC2808A-2Q1是汽车类低功耗电流模式推挽 PWM,本站介绍了UCC2808A-2Q1的封装应用图解、特点和优点、功能等,并给出了与UCC2808A-2Q1相关的TI元器件型号供参考。
UCC2808A-2Q1 - 汽车类低功耗电流模式推挽 PWM - PWM与谐振控制器 - 离线隔离型DC/DC控制器和转换器 - 德州仪器
The UCC2808A-xQ1 is a family of BiCMOS push-pull, high-speed, low-power, pulse-width modulators. The UCC2808A-xQ1 contains all of the control and drive circuitry required for off-line or DC-to-DC fixed frequency current-mode switching power supplies with minimal external parts count.
The UCC2808A-xQ1 dual output drive stages are arranged in a push-pull configuration. Both outputs switch at half the oscillator frequency using a toggle flip-flop. The dead time between the two outputs is typically 60 ns to 200 ns depending on the values of the timing capacitor and resistors, thus limiting each output stage duty cycle to less than 50%.
The UCC2808A-xQ1 family offers a variety of package options and choice of undervoltage lockout levels. The family has UVLO thresholds and hysteresis options for off-line and battery powered systems. Thresholds are shown in the ordering information table.
The UCC2808A-xQ1 is an enhanced version of the UCC2808 family. The significant difference is that the A versions feature an internal discharge transistor from the CS pin to ground, which is activated each clock cycle during the oscillator dead time. The feature discharges any filter capacitance on the CS pin during each cycle and helps minimize filter capacitor values and current sense delay.
- Qualified for Automotive Applications
- ESD Protection Exceeds 1500 V Per MIL-STD-883, Method 3015; Exceeds 200 V Using Machine Model (C = 200 pF, R = 0)
- Dual Output Drive Stages in Push-Pull Configuration
- Current Sense Discharge Transistor to Improve Dynamic Response
- 130-µA Typical Starting Current
- 1-mA Typical Run Current
- Operation to 1 MHz
- Internal Soft Start
- On-Chip Error Amplifier With 2-MHz Gain Bandwidth Product
- On Chip VDD Clamping
- Output Drive Stages Capable of 500-mA Peak-Source Current, 1-A Peak-Sink Current
- DS90UB913Q-Q1 - DS90UB913Q/4Q 10-100MHz 10/12 位 FPD-Link III 串行器/解串器
- TMP512 - 采用双路远程和本地温度传感器以及电流分流监控器的热/功率管理
- TPS51275B-1 - TPS51275B-1 含 5V 和 3.3V 低压差稳压器 (LDO) 的双同步、降压控制器
- ADS8558 - 730kSPS、12 位、6 通道同步采样模数转换器
- UA78L05 - 3/8 引脚 100mA 固定 5V 正电压稳压器
- SN74LS85 - 4 位二进制或 BCD 幅度比较器
- SN65HVD1780 - 具有故障保护功能的 70V RS-485 收发器
- SN65LVDS386 - 16 通道 LVDS 接收器
- TPS6735 - 固定负 5V 200MA 反向 DC/DC 转换器
- UCC27517A-Q1 - 具有 5V 负输入电压处理能力的 4A/4A 单通道高速低侧栅极驱动器



